Home › Engine / Hybrid System › 2GR-FE ENGINE MECHANICAL › DRIVE BELT
RM2030EQ _51 Engine / Hybrid System _014635 2GR-FE ENGINE MECHANICAL _0074411 DRIVE BELT G

2GR-FE ENGINE MECHANICAL  DRIVE BELT  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16361A 1.INSPECT V-RIBBED BELT

a.
A058797
1.24,0.156 1.438,0.323 0.198,0.167 10 *a
*a INCORRECT


Check the belt for wear, cracks or other signs of damage.

If any of the following defects is found, replace the V-ribbed belt.

·

The belt is cracked.

·

The belt is worn out to the extent that the cords are exposed.

·

The belt has chunks missing from the ribs.



b.
A087787
0.531,1.156 0.719,1.313 0.188,0.156 10 false *a 2.198,1.156 2.385,1.323 0.188,0.167 10 false *b
*a CORRECT
*b INCORRECT


Check that the belt fits properly in the ribbed grooves.

HINT:

Check with your hand to confirm that the belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the V-ribbed. Install a new V-ribbed correctly.