Home › Engine / Hybrid System › 2GR-FE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL
RM2030EQ _51 Engine / Hybrid System _014635 2GR-FE ENGINE MECHANICAL _0074414 FRONT CRANKSHAFT OIL SEAL A

2GR-FE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11301C 1.INSTALL TIMING CHAIN CASE OIL SEAL

a.
A124982C02
1.844,0.719 1.51,0.438 1.51,0.438 2.271,0.542 false 1.99,0.25 2.156,0.427 0.167,0.177 10 *a 1.188,0.354 1.51,0.531 0.323,0.177 10 SST
*a Oil seal tap in depth
(0 to 1.0 mm)


Apply MP grease to a new timing chain case oil seal lip.


b.

Using SST and a hammer, tap in the timing chain case oil seal until its surface is flush with the timing chain cover edge.

SST
09223-22010  
09506-35010  

Oil seal tap in depth:

0 to 1.0 mm (0 to 0.0393 in.)


NOTICE:
·

Keep the lip free of foreign matter.

·

Do not tap the timing chain case oil seal at an angle.




Hide 13471 2.INSTALL CRANKSHAFT PULLEY

HINT:
A366722C01
0.385,0.25 0.802,0.531 0.417,0.281 12 false *A 2.135,0.24 2.542,0.552 0.406,0.313 12 false *B
*A Type A
*B Type B


Type A and Type B can be distinguished by the number on the head of the pulley bolt.

Type Number on the Head
A 11
B 10


a.

Install the pulley set key to the crankshaft.


b.

Align the pulley set key with the key groove of the pulley, and slide on the pulley.


c.
A208602C02
2.104,1.677 2.573,0.875 2.573,0.875 2.344,2 false 2.615,0.771 2.917,0.927 0.302,0.156 10 false SST 0.198,2.385 0.365,2.563 0.167,0.177 10 false *a
*a Hold
V100135

Turn


Using SST, install the pulley bolt.

SST
09213-70011  (09213-70020)
09330-00021  

Torque:
Type A : 260 N*m (2651 kgf*cm, 192 ft.*lbf)
Type B : 250 N*m (2549 kgf*cm, 184 ft.*lbf)


Hide 53736 4.INSTALL FRONT FENDER APRON SEAL RH

Hide 51441C 5.INSTALL ENGINE UNDER COVER RH

Hide 53851Z 6.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (for RHD)

Hide 7.INSTALL FRONT WHEEL RH

Torque:
103 N*m (1049 kgf*cm, 76 ft.*lbf)