Home › Engine / Hybrid System › 2GR-FE ENGINE MECHANICAL › CYLINDER HEAD
RM2030EQ _51 Engine / Hybrid System _014635 2GR-FE ENGINE MECHANICAL _0074418 CYLINDER HEAD A

2GR-FE ENGINE MECHANICAL  CYLINDER HEAD  REPAIR  


PROCEDURE

Hide 11131 1.REPAIR INTAKE VALVE SEAT

NOTICE:
·

Repair the intake valve seat while checking the seating position.

·

Keep the lip free of foreign matter.



a.
A127139

Using a 45° cutter, resurface the valve seat so that the valve seat width is greater than the specification.


b.
A293061
2.583,1.74 2.896,1.896 0.313,0.156 10 *a 3.083,0.583 3.427,0.75 0.344,0.167 10 30° 2.625,0.094 3.083,0.292 0.458,0.198 10 60° 2.896,0.292 3.354,0.49 0.458,0.198 10 45°
*a Width


Using 30° and 60° cutters, correct the valve seat so that the intake valve contacts the entire circumference of the seat. The contact should be in the center of the intake valve seat, and the intake valve seat width should be maintained within the specified range around the entire circumference of the intake valve seat.

Width:

1.1 to 1.5 mm (0.0433 to 0.0591 in.)



c.

Handrub the intake valve and intake valve seat with an abrasive compound.


d.

Check the intake valve seating position.


Hide 11135 2.REPAIR EXHAUST VALVE SEAT

NOTICE:
·

Repair the seat while checking the seating position.

·

Keep the lip free of foreign matter.



a.
A127140

Using a 45° cutter, resurface the valve seat so that the valve seat width is greater than the specification.


b.
A124255
2.539,0.0 2.78,0.161 0.241,0.161 10 75° 2.943,0.105 3.184,0.266 0.241,0.161 10 45° 3.14,0.382 3.381,0.543 0.241,0.161 10 30° 2.849,1.743 3.276,1.927 0.427,0.183 10 *a
*a Width


Using 30° and 75° cutters, correct the exhaust valve seat so that the exhaust valve contacts the entire circumference of the seat. The contact should be in the center of the exhaust valve seat, and the exhaust valve seat width should be maintained within the specified range around the entire circumference of the exhaust valve seat.

Width:

1.1 to 1.5 mm (0.0433 to 0.0591 in.)



c.

Handrub the exhaust valve and exhaust valve seat with an abrasive compound.


d.

Check the exhaust valve seating position.