Home › Engine / Hybrid System › 2GR-FE FUEL › FUEL PUMP
RM2030EQ _51 Engine / Hybrid System _014636 2GR-FE FUEL _0074423 FUEL PUMP G

2GR-FE FUEL  FUEL PUMP  INSPECTION  


PROCEDURE

Hide 23221 1.INSPECT FUEL PUMP

a.
A171472
1.281,1.01 1.844,1.01 1.844,1.01 1.844,1.104 false 0.906,1.01 0.344,1.01 0.344,1.01 0.344,1.104 false 0.313,1.125 0.438,1.313 0.125,0.188 10 1 1.823,1.115 1.938,1.323 0.115,0.208 10 2 1.354,1.094 1.469,1.229 0.115,0.135 10 + 0.792,1.094 0.896,1.24 0.104,0.146 10 - 1.344,1.333 1.5,1.531 0.156,0.198 10 + 0.802,1.313 0.958,1.51 0.156,0.198 10 -

Check the fuel pump resistance.

i.

Using an ohmmeter, measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.2 to 3.0 Ω


If the result is not as specified, replace the fuel pump.



b.

Check fuel pump operation.

i.

Apply battery voltage to terminals 1 and 2. Check that the pump operates.

NOTICE:
·

These tests must be done quickly (within 10 seconds) to prevent the coil from burning out.

·

Keep the fuel pump as far away from the battery as possible.

·

Always switch the voltage on and off at the battery side, not the fuel pump side.



If the pump does not operate, replace the fuel pump.