Home › Engine / Hybrid System › 2GR-FE INTAKE / EXHAUST › VACUUM SWITCHING VALVE(for Intake Air Control System)
RM2030EQ _51 Engine / Hybrid System _014638 2GR-FE INTAKE / EXHAUST _0074437 VACUUM SWITCHING VALVE(for Intake Air Control System) G

2GR-FE INTAKE / EXHAUST  VACUUM SWITCHING VALVE(for Intake Air Control System)  INSPECTION  


PROCEDURE

Hide 17650Q 1.INSPECT VACUUM SWITCHING VALVE

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 37 to 44 Ω
1 - Valve body Always 10 kΩ or higher
2 - Valve body


If the result is not as specified, replace the vacuum switching valve.


b.
A254377
2.396,0.813 2.781,0.813 false 0.948,1.323 0.531,1.323 false 1.115,1.177 0.74,0.688 0.74,0.688 0.531,0.688 false 0.375,1.24 0.531,1.406 0.156,0.167 10 *b 0.375,0.594 0.583,0.813 0.208,0.219 10 *a 2.865,0.75 3.01,0.896 0.146,0.146 10 *1
*1 Filter
*a Port E
*b Port F


Using a vacuum pump, check that air flows through the vacuum switching valve as specified.

OK:
Measurement Condition Specified Condition
Battery voltage applied between terminals 1 and 2 and vacuum applied to port F. Air is sucked into port E.
Battery voltage not applied between terminals 1 and 2 and vacuum applied to port E. Air is sucked into filter.


If the result is not as specified, replace the vacuum switching valve.