89465
1.INSTALL HEATED OXYGEN SENSOR (for Bank 2)
89465
2.INSTALL HEATED OXYGEN SENSOR (for Bank 1)
17410
3.INSTALL FRONT EXHAUST PIPE ASSEMBLY
Install 2 new gaskets to the front exhaust pipe assembly.
Connect the front exhaust pipe assembly to the No. 1 exhaust pipe support bracket (for Rear Side).
Install the front exhaust pipe assembly with the 2 bolts and 2 nuts.
Connect the 2 heated oxygen sensor connectors.
Install the 2 wire harnesses to the clamp.
17584B
4.INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Front Side)
Install the No. 1 exhaust pipe support bracket with the 2 nuts (for Front Side).
51441C
5.INSTALL ENGINE UNDER COVER RH
53851Z
6.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
17420
7.INSTALL CENTER EXHAUST PIPE ASSEMBLY
Install a new gasket to the front exhaust pipe assembly.
Connect the center exhaust pipe assembly to the exhaust pipe supports.
Install the center exhaust pipe assembly with the 2 bolts and 2 nuts.
17581A
8.INSTALL EXHAUST PIPE DAMPER
Install the exhaust pipe damper with the 2 bolts.
17430
9.INSTALL TAIL EXHAUST PIPE ASSEMBLY
Install a new gasket to the center exhaust pipe assembly.
Connect the tail exhaust pipe assembly to the 3 exhaust pipe supports.
Install the tail exhaust pipe assembly with the 2 nuts.
17440
10.INSTALL TAIL EXHAUST PIPE ASSEMBLY LH
Install a new gasket to the center exhaust pipe assembly.
Connect the tail exhaust pipe assembly LH to the 2 exhaust pipe supports.
Install the tail exhaust pipe assembly LH with the 2 nuts.
11.INSPECT FOR EXHAUST GAS LEAK