Home › Engine / Hybrid System › 2GR-FE INTAKE / EXHAUST › EXHAUST PIPE
RM2030EQ _51 Engine / Hybrid System _014638 2GR-FE INTAKE / EXHAUST _0074439 EXHAUST PIPE A

2GR-FE INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


PROCEDURE

Hide 17440 1.REMOVE TAIL EXHAUST PIPE ASSEMBLY LH

a.
A255356

Remove the 2 nuts.


b.

Remove the tail exhaust pipe assembly LH from the 2 exhaust pipe supports.


c.

Remove the gasket from the center exhaust pipe assembly.


Hide 17430 2.REMOVE TAIL EXHAUST PIPE ASSEMBLY

a.
A255355

Remove the 2 nuts.


b.

Remove the tail exhaust pipe assembly from the 3 exhaust pipe supports.


c.

Remove the gasket from the center exhaust pipe assembly.


Hide 17581A 3.REMOVE EXHAUST PIPE DAMPER

a.
A255358

Remove the 2 bolts and exhaust pipe damper.


Hide 17420 4.REMOVE CENTER EXHAUST PIPE ASSEMBLY

a.
A255359

Remove the 2 bolts and 2 nuts.


b.

Remove the center exhaust pipe assembly from the 2 exhaust pipe supports.


c.

Remove the gasket from the front exhaust pipe assembly.


Hide 53851Z 5.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

Hide 51441C 6.REMOVE ENGINE UNDER COVER RH

Hide 17584B 7.REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Front Side)

a.
A255354

Remove the 2 nuts and No. 1 exhaust pipe support bracket (for Front Side).


Hide 17410 8.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.
A255349

Disconnect the 2 wire harnesses from the clamp.


b.

Disconnect the 2 heated oxygen sensor connectors.


c.
A255360

Remove the 2 bolts and 2 nuts.


d.

Remove the front exhaust pipe assembly from the No. 1 exhaust pipe support bracket (for Rear Side).


e.

Remove the 2 gaskets from the front exhaust pipe assembly.


Hide 89465 9.REMOVE HEATED OXYGEN SENSOR (for Bank 1)

Hide 89465 10.REMOVE HEATED OXYGEN SENSOR (for Bank 2)