Home › Engine / Hybrid System › 2GR-FE COOLING › COOLING FAN ECU
RM2030EQ _51 Engine / Hybrid System _014639 2GR-FE COOLING _0074446 COOLING FAN ECU G

2GR-FE COOLING  COOLING FAN ECU  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89257 1.INSPECT COOLING FAN ECU

a.

Put the vehicle in the following conditions:

i.

The ignition switch is off.


ii.

The coolant temperature is less than 92°C (198°F).


iii.

The battery voltage is between 11 to 14 V.


iv.

The A/C switch is off.



b.

Connect the pickup of a clamp-on ammeter over one of the two wires for the cooling fan motor.


c.

Turn the ignition switch on and wait for approximately 10 seconds. Check that the fan stops.


d.

Start the engine. Check that the fan stops with the engine idling.

HINT:
·

Make sure that the radiator engine coolant temperature is less than 92°C (198°F).


·

Turn the A/C switch off.




e.

Check that the fan operates when the A/C switch is turned on.

Standard Current:
Item Specified Condition
Cooling fan motor 14.2 to 20.2 A
No. 2 cooling fan motor 14.2 to 20.2 A


HINT:

The coolant temperature is less than 92°C (198°F).



f.

Check that the fan operates when the engine coolant temperature sensor connector is disconnected.

Standard Current:
Item Specified Condition
Cooling fan motor 14.2 to 20.2 A
No. 2 cooling fan motor 14.2 to 20.2 A



g.
A280134
1.135,0 2.365,0.177 1.229,0.177 10 false Operating Diagram 1.552,0.479 2.146,0.635 0.594,0.156 10 false A/C OFF 0.031,0.771 0.531,0.917 0.5,0.146 10 false MAX HI 0.375,2.427 0.583,2.583 0.208,0.156 10 false LO 0.052,1.427 0.583,1.917 0.531,0.49 10 false Fan Speed 0.802,3.469 1,3.625 0.198,0.156 10 false 92 1.146,3.469 1.344,3.625 0.198,0.156 10 false 94 2.427,3.469 2.698,3.625 0.271,0.156 10 false 100 2.792,3.469 3.042,3.625 0.25,0.156 10 false 102 0.688,3.813 0.958,3.969 0.271,0.156 10 false 198 1.083,3.813 1.354,3.969 0.271,0.156 10 false 201 2.448,3.813 2.719,3.969 0.271,0.156 10 false 212 2.802,3.813 3.073,3.969 0.271,0.156 10 false 216 3.104,3.813 3.375,3.969 0.271,0.156 10 false (°F) 3.104,3.438 3.385,3.625 0.281,0.188 10 false (°C) 1.5,3.469 1.698,3.625 0.198,0.156 10 false 97 1.458,3.813 1.729,3.969 0.271,0.156 10 false 207 2.156,3.469 2.354,3.625 0.198,0.156 10 false 99 2.115,3.813 2.385,3.969 0.271,0.156 10 false 210

After the engine is warmed up, check that the fan operates as shown in the illustration.

HINT:
·

The coolant temperature at which the fan starts operating is approximately 94°C (201°F).

·

This system can also be checked using the intelligent tester.

·

Select the following menu items: Powertrain / Engine / Data List / Coolant Temp.