Home › Engine / Hybrid System › 2GR-FE COOLING › RADIATOR
RM2030EQ _51 Engine / Hybrid System _014639 2GR-FE COOLING _0074447 RADIATOR G

2GR-FE COOLING  RADIATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16401 1. CHECK RADIATOR CAP SUB-ASSEMBLY

a.
A107446
1.052,1.615 1.208,1.792 0.156,0.177 10 3 0.542,1.052 0.698,1.229 0.156,0.177 10 1 0.771,1.292 0.927,1.469 0.156,0.177 10 2 2.354,1.583 2.51,1.771 0.156,0.188 10 4

Measure the valve opening pressure.

i.

If there are water stains or foreign matter on rubber packings 1, 2 or 3, clean the part(s) with water and finger scouring.


ii.

Check that rubber packings 1, 2 and 3 are not deformed, cracked or swollen.


iii.

Check that 3 and 4 are not stuck together.


iv.

Apply engine coolant to rubber packings 2 and 3 before using the radiator cap tester.


v.

When using the cap tester, tilt it upward 30° or more.


vi.
A104601
0.406,0.896 0.542,1.552 false 1.656,0.802 1.771,0.406 false 1.708,0.177 1.896,0.375 0.188,0.198 10 *1 1.5,1.24 1.688,1.438 0.188,0.198 10 *a 0.479,1.583 0.667,1.781 0.188,0.198 10 *2
*1 Radiator Cap Tester
*2 Radiator Cap Sub-assembly
*a 30° or more


Pump the cap tester several times, and check the maximum pressure *1.

Pumping speed:

1 pump every second


*1: Even if the cap cannot maintain the maximum pressure, it is not a defect.

Judgment Criteria:
Item Specified Condition
Standard value
(for brand-new cap)
93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
Minimum standard value
(for used cap)
78.5 kPa (0.8 kgf/cm2, 11.4 psi)


If the maximum pressure is less than the specified pressure for the minimum standard value, replace the radiator cap sub-assembly.