Home › Engine / Hybrid System › 2GR-FE LUBRICATION › OIL PUMP
RM2030EQ _51 Engine / Hybrid System _014640 2GR-FE LUBRICATION _0074449 OIL PUMP G

2GR-FE LUBRICATION  OIL PUMP  INSPECTION  


PROCEDURE

Hide 1.INSPECT OIL PUMP RELIEF VALVE

a.
A094628

Coat the relief valve with engine oil and check that it falls smoothly into the valve hole by its own weight.

If the valve does not fall smoothly, replace the relief valve. If necessary, replace the oil pump assembly.


Hide 2.INSPECT OIL PUMP ROTOR SET

a.
A128010
1.542,0.188 1.542,0.229 false 1.469,1.104 1.469,1.135 false 1.542,0.208 1.323,0.208 false 1.469,1.115 2.479,1.448 false 1.156,0.125 1.323,0.292 0.167,0.167 10 false *a 2.531,1.375 2.698,1.542 0.167,0.167 10 false *a
*a Mark


Install the rotors to the timing chain cover with the rotor marks facing up. Check that the rotors rotate smoothly.


b.
A128011

Check the tip clearance.

i.

Using a feeler gauge, measure the clearance between the drive and driven rotor tips as shown in the illustration.

Tip Clearance:
Standard:

0.060 to 0.160 mm (0.00236 to 0.00630 in.)

Maximum:

0.160 mm (0.00630 in.)


If the tip clearance is greater than the maximum, replace the timing chain cover sub-assembly.



c.
A128012

Check the side clearance.

i.

Using a feeler gauge and precision straightedge, measure the clearance between the rotors and precision straightedge as shown in the illustration.

Side Clearance:
Standard:

0.030 to 0.090 mm (0.00118 to 0.00354 in.)

Maximum:

0.090 mm (0.00354 in.)


If the side clearance is greater than the maximum, replace the timing chain cover sub-assembly.



d.
A128013

Check the body clearance.

i.

Using a feeler gauge, measure the clearance between the timing chain cover and driven rotor as shown in the illustration.

Body Clearance:
Standard:

0.250 to 0.325 mm (0.00984 to 0.0128 in.)

Maximum:

0.325 mm (0.0128 in.)


If the body clearance is greater than the maximum, replace the timing chain cover sub-assembly.