Home › Engine / Hybrid System › 2GR-FE LUBRICATION › OIL PRESSURE SWITCH
RM2030EQ _51 Engine / Hybrid System _014640 2GR-FE LUBRICATION _0074452 OIL PRESSURE SWITCH G

2GR-FE LUBRICATION  OIL PRESSURE SWITCH  INSPECTION  


PROCEDURE

Hide 83530 1.INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

Disconnect the oil pressure switch assembly connector.


b.

Start the engine.


c.
A159695

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - Switch body Idling 10 kΩ or higher
1 - Switch body Engine stopped Below 1 Ω


If the result is not as specified, replace the oil pressure switch assembly.


d.

Reconnect the oil pressure switch assembly connector.