Home › Engine / Hybrid System › 2GR-FE STARTING › STARTER
RM2030EQ _51 Engine / Hybrid System _014641 2GR-FE STARTING _0074455 STARTER A

2GR-FE STARTING  STARTER  DISASSEMBLY  


PROCEDURE

Hide 28150 1.REMOVE MAGNET STARTER SWITCH ASSEMBLY

a.
A194756

Remove the nut and disconnect the lead wire from the magnet starter switch assembly.


b.
A194757

Remove the 2 nuts holding the magnet starter switch to the repair service starter kit.


c.

Remove the magnet starter switch.


Hide 28120 2.REMOVE STARTER YOKE ASSEMBLY

a.
A194758

Remove the 2 through-bolts, and pull out the starter yoke assembly together with the starter commutator end frame assembly.


b.
A194759

Remove the starter yoke assembly from the starter commutator end frame assembly.


Hide 28177 3.REMOVE STARTER ARMATURE PLATE

a.
A194760

Remove the starter armature plate from the starter yoke.


Hide 28132A 4.REMOVE STARTER COMMUTATOR END FRAME COVER

a.
A194761

Using a screwdriver, pry out the starter commutator end frame cover to remove it.


Hide 28160 5.REMOVE STARTER ARMATURE ASSEMBLY

a.
A194762
1.74,0.479 1.458,0.292 1.458,0.292 1.333,0.292 false 1.177,0.219 1.375,0.406 0.198,0.188 10 false *1
*1 Snap Ring Pliers


Using snap ring pliers, remove the snap ring and washer.


b.

Remove the starter armature assembly from the starter commutator end frame cover.

NOTICE:

Do not drop the starter armature.



Hide 28117A 6.REMOVE RUBBER SEAL

a.
A194763

Remove the rubber seal from the repair service starter kit.


Hide 28255 7.REMOVE PLANETARY GEAR

a.
A194764

Remove the 3 planetary gears from the repair service starter kit.