Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH
RM2030EQ _51 Engine / Hybrid System _014642 CRUISE CONTROL _0074460 CRUISE CONTROL MAIN SWITCH G

CRUISE CONTROL  CRUISE CONTROL MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84632 1.INSPECT CRUISE CONTROL SWITCH

a.

Measure the resistance according to the value(s) in the table below.

E266303
5.51,1.083 5.885,0.604 5.885,0.604 6.031,0.604 false 6.063,0.5 6.427,0.719 0.365,0.219 10 false *1 0.135,0.104 0.635,0.427 0.5,0.323 10 false *a 6.344,1.167 6.698,1.375 0.354,0.208 10 false *b 5.042,0.417 5.448,0.688 0.406,0.271 10 false *c 5.521,2.229 5.958,2.469 0.438,0.24 10 false *d 4.271,2.031 4.656,2.26 0.385,0.229 10 false *e
*1 Cruise Control Switch (ON-OFF button) - -
*a Component without harness connected (Cruise Control Switch) *b ON-OFF
*c +/RES *d -/SET
*e CANCEL - -


Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - 3 Cruise control switch (ON-OFF button) released 1 MΩ or higher
Cruise control switch (ON-OFF button) pushed Below 2.5 Ω
+/RES 235 to 245 Ω
-/SET 617 to 643 Ω
CANCEL 1509 to 1571 Ω