Home › Drivetrain › U660E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE FLUID
RM2030EQ _52 Drivetrain _014643 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0074462 AUTOMATIC TRANSAXLE FLUID A

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE FLUID  REPLACEMENT  


PROCEDURE

Hide 1.REPLACE AUTOMATIC TRANSAXLE FLUID

a.

Lift the vehicle. [*1]

NOTICE:

Set the vehicle on a lift so that the vehicle is kept level when it is lifted up (make sure that the tilt angle from the front to rear of the vehicle is within +/- 1°).



b.

for LHD:

i.

Remove the engine under cover LH and front fender apron seal LH.



c.

for RHD:

i.

Remove the front wheel opening extension pad LH, engine under cover LH and front fender apron seal LH.



d.
C201682

Remove the refill plug and gasket from the automatic transaxle assembly. [*2]


e.
C239660

Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the automatic transaxle oil pan sub-assembly. [*3]


f.
C201684
1.22,2.592 1.376,2.756 0.155,0.165 10 *1 1.22,3.134 1.384,3.296 0.164,0.162 10 *2 0.659,3.847 0.84,4.037 0.181,0.19 10 *a 1.205,2.679 0.835,2.679 false 0.603,3.928 0.414,3.928 0.414,3.928 0.713,3.129 false 1.205,3.214 0.83,3.214 false
*1 No. 1 Transmission Oil Filler Tube
*2 Hexagon Socket Wrench
*a Overflow Plug Hole


Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the automatic transaxle oil pan sub-assembly and drain the automatic transaxle fluid. [*4]


g.
C239510

Measure the amount of fluid that you drained. [*5]

HINT:

Add the same amount of fluid in step [*8].



h.

Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the automatic transaxle oil pan sub-assembly. [*6]

Torque:
1.7 N*m (17 kgf*cm, 15 in.*lbf)


i.
C239660

Temporarily install the gasket and overflow plug. [*7]

HINT:

Reuse the old gasket. The plug will be removed again to adjust the fluid level.



j.
C239936

Add fluid to the refill hole using the same amount of fluid drained in step [*5]. [*8]

NOTICE:

Use Toyota Genuine ATF WS.



k.
C201682

Temporarily install the gasket and refill plug to avoid fluid spillage. [*9]

HINT:

Reuse the old gasket. The plug will be removed again to adjust the fluid level.



l.

Lower the vehicle. [*10]


m.

Start the engine. [*11]


n.

Slowly move the shift lever from P to D, and then back to P. [*12]


o.

Allow the engine to idle for 30 seconds to warm it up. [*13]


p.

Turn the engine switch off. [*14]


q.

Repeat steps [*1] to [*14].


r.

Repeat steps [*1] to [*10].