Home › Drivetrain › U660E AUTOMATIC TRANSMISSION / TRANSAXLE › VALVE BODY ASSEMBLY
RM2030EQ _52 Drivetrain _014643 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0074466 VALVE BODY ASSEMBLY G

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  VALVE BODY ASSEMBLY  INSPECTION  


PROCEDURE

Hide 1.INSPECT SHIFT SOLENOID VALVE SL

a.
C188295
0.158,0.099 0.355,0.264 0.197,0.164 10 *a
*a Shift Solenoid Valve SL


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Solenoid Connector (SL) - Solenoid Body (SL) 20°C (68°F) 11 to 15 Ω


If the value is not as specified, replace the shift solenoid valve.


b.

Connect a positive (+) lead from the battery to the terminal of the solenoid connector, and a negative (-) lead to the solenoid body, and check the operation of the valve.

NOTICE:

When using battery voltage during the inspection, do not bring the positive (+) and negative (-) tester probes too close to each other as a short circuit may occur.


OK:

The valve moves and makes an operating sound.


If the operation cannot be done as specified, replace the shift solenoid valve.


Hide 2.INSPECT SHIFT SOLENOID VALVE (SLT, SLU, SL1, SL2, SL3, SL4)

a.
C201747
0.493,0.48 0.674,0.675 0.18,0.195 10 1 2.533,0.48 2.713,0.675 0.18,0.195 10 2 1.163,4.15 1.372,4.356 0.209,0.206 10 (-) 1.919,4.15 2.147,4.35 0.228,0.2 10 (+) 1.509,0.804 0.652,0.57 false 1.785,0.789 2.479,0.549 false 0.493,2.733 0.674,2.928 0.18,0.195 10 1 2.533,2.733 2.713,2.928 0.18,0.195 10 2 1.509,3.056 0.652,2.823 false 1.785,3.042 2.479,2.802 false 0.135,0.025 0.357,0.231 0.222,0.206 10 *a
*a Component without harness connected
(Shift Solenoid Valve SLT, SLU, SL1, SL2, SL3, SL4)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 5.0 to 5.6 Ω


If the value is not as specified, replace the shift solenoid valve.


b.

Connect a positive (+) lead from the battery with a 21 W bulb to terminal 2 and a negative (-) lead to terminal 1 of the solenoid valve connector, and check the operation of the valve.

NOTICE:

When using battery voltage during the inspection, do not bring the positive (+) and negative (-) tester probes too close to each other as a short circuit may occur.


OK:

The valve moves and makes an operating sound.


If the operation cannot be done as specified, replace the shift solenoid valve.