Home › Drivetrain › U660E AUTOMATIC TRANSMISSION / TRANSAXLE › OIL PUMP
RM2030EQ _52 Drivetrain _014643 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0074475 OIL PUMP G

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  OIL PUMP  INSPECTION  


PROCEDURE

Hide 35035 1.INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY

a.
C138512

Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

NOTICE:

Be careful not to damage the oil seal lip.



Hide 35035 2.INSPECT CLEARANCE OF FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY

a.
C138509

Push the driven gear to one side of the front oil pump body sub-assembly.


b.

Using a feeler gauge, measure the clearance.

Standard clearance:

0.08 to 0.15 mm (0.00315 to 0.00591 in.)


Maximum clearance:

0.15 mm (0.00591 in.)


If the clearance is greater than the maximum, replace the front oil pump body sub-assembly.


c.
C138511

Using a straightedge and feeler gauge, measure the side clearance of both gears.

Standard side clearance:

0.025 to 0.04 mm (0.000984 to 0.00157 in.)


Maximum side clearance:

0.04 mm (0.00157 in.)

Drive Gear Thickness
Mark Thickness
1 11.547 to 11.555 mm (0.4546 to 0.4549 in.)
2 11.555 to 11.563 mm (0.4549 to 0.4552 in.)
3 11.564 to 11.571 mm (0.4553 to 0.4556 in.)
4 11.572 to 11.579 mm (0.4556 to 0.4559 in.)
5 11.580 to 11.587 mm (0.4559 to 0.4562 in.)

Driven Gear Thickness
Mark Thickness
1 11.547 to 11.555 mm (0.4546 to 0.4549 in.)
2 11.555 to 11.563 mm (0.4549 to 0.4552 in.)
3 11.564 to 11.571 mm (0.4553 to 0.4556 in.)
4 11.572 to 11.579 mm (0.4556 to 0.4559 in.)
5 11.580 to 11.587 mm (0.4559 to 0.4562 in.)



Hide 35035 3.INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY

a.
C138514

Using a dial indicator, measure the inside diameter of the front oil pump body bushing.

Standard inside diameter:

43.113 to 43.138 mm (1.6974 to 1.6983 in.)


Maximum inside diameter:

43.188 mm (1.7003 in.)


If the inside diameter is greater than the maximum, replace the front oil pump body sub-assembly.


Hide 35370 4.INSPECT STATOR SHAFT ASSEMBLY

a.
C138513

Using a dial indicator, measure the inside diameter of the stator shaft assembly.

Standard inside diameter:

22.500 to 22.526 mm (0.8858 to 0.8868 in.)


Maximum inside diameter:

22.570 mm (0.8886 in.)


If the inside diameter is greater than the maximum, replace the stator shaft assembly.