43448G
1.REMOVE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP
Hold the drive shaft in a vise between aluminum plates.
Do not overtighten the vise.
Using pliers, remove the front No. 2 axle inboard joint boot clamp.
43448F
2.REMOVE FRONT AXLE INBOARD JOINT BOOT CLAMP
Perform the same procedure as for the front No. 2 axle inboard joint boot clamp.
3.SEPARATE FRONT AXLE INBOARD JOINT BOOT
Separate the front axle inboard joint boot from the front drive inboard joint assembly.
4.REMOVE FRONT DRIVE INBOARD JOINT ASSEMBLY
Remove the old grease from the front drive inboard joint assembly.
| *a | Matchmark |
Put matchmarks on the front drive inboard joint assembly and front drive outboard joint shaft assembly.
Do not use a punch for the marks.
Remove the front drive inboard joint assembly from the front drive outboard joint shaft assembly.
Hold the drive shaft in a vise between aluminum plates.
Do not overtighten the vise.
Using a snap ring expander, remove the shaft snap ring from the front drive outboard joint shaft assembly.
| *a | Matchmark |
Put matchmarks on the front drive outboard joint shaft assembly and tripod joint.
Do not use a punch for the marks.
Using a brass bar and a hammer, tap out the tripod joint from the front drive outboard joint shaft assembly.
Do not tap the rollers.
Do not drop the tripod joint.
5.REMOVE FRONT AXLE INBOARD JOINT BOOT
Remove the front No. 2 axle inboard joint boot clamp, front axle inboard joint boot and front axle inboard joint boot clamp.
43474E
6.REMOVE FRONT DRIVE SHAFT DAMPER (w/ 1 Clamp)
Using pliers, remove the front drive shaft damper clamp.
Remove the front drive shaft damper.
43474E
7.REMOVE FRONT DRIVE SHAFT DAMPER (w/ 2 Clamps)
Using needle-nose pliers, remove the 2 front drive shaft damper clamps.
Remove the front drive shaft damper.
43447F
8.REMOVE FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP
Using pliers, remove the front No. 2 axle outboard joint boot clamp.
43447E
9.REMOVE FRONT AXLE OUTBOARD JOINT BOOT CLAMP
Perform the same procedure as for the front No. 2 axle outboard joint boot clamp.
10.REMOVE FRONT AXLE OUTBOARD JOINT BOOT
Remove the front axle outboard joint boot clamp, front axle outboard joint boot and front No. 2 axle outboard joint boot clamp from the front drive outboard joint shaft assembly.
Remove the grease from the outboard joint.
41336E
11.REMOVE FRONT DRIVE SHAFT DUST COVER LH
Using SST and a press, remove the front drive shaft dust cover LH.
Be careful not to drop the front drive inboard joint assembly.
Do not overtighten SST.
41336D
12.REMOVE FRONT DRIVE SHAFT DUST COVER RH
Using a press, remove the front drive shaft dust cover RH.
Be careful not to drop the front drive inboard joint assembly.
43458
13.REMOVE FRONT DRIVE SHAFT DUST COVER (for RH Side)
w /Cover:
Using SST and a press, remove the front drive shaft dust cover.
Be careful not to drop the front drive inboard joint assembly.
Do not overtighten SST.
If the front drive shaft dust cover is removed, it is not necessary to reinstall it.
43410C
14.REMOVE FRONT DRIVE SHAFT BEARING (for RH Side)
Using a snap ring expander, remove the drive shaft hole snap ring.
Using SST and a press, remove the front drive shaft bearing.
Be careful not to drop the front drive inboard joint assembly.