Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR
RM2030EQ _54 Brake _014650 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0074504 BRAKE ACTUATOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.SEPARATE SUCTION PIPE CLAMP

a.
C239179

Disengage the suction pipe clamp to separate it from the brake actuator bracket assembly.


Hide 4.REMOVE BRAKE ACTUATOR WITH BRACKET

a.
C239180N03
2.135,1.646 2.354,1.865 2.354,1.865 2.729,1.865 true 1.646,2.917 1.292,2.573 1.292,2.573 0.875,2.573 true 2.74,1.771 3.208,2.146 0.469,0.375 10 false a 0.75,2.49 1.521,2.885 0.771,0.396 10 false b

Disengage the claw (a) and raise the lock lever.


b.

Engage the claw (b) and disconnect the connector from the brake actuator assembly.

NOTICE:

Be careful not to allow any brake fluid to enter the connector.



c.
C239182C01
1.885,0.49 2.51,0.219 true 1.656,0.615 0.865,0.177 true 1.51,0.771 0.823,0.552 true 1.375,0.927 0.573,1.083 true 1.792,1.208 1.906,1.792 true 2.042,0.948 2.292,1.542 true 1.833,1.771 2.24,2 0.406,0.229 10 false *a 2.24,1.563 2.844,1.854 0.604,0.292 10 false *b 2.531,0.115 2.99,0.396 0.458,0.281 10 false *c 0.688,0.073 1.083,0.344 0.396,0.271 10 false *d 0.646,0.458 1.083,0.771 0.438,0.313 10 false *e 0.438,1 0.875,1.292 0.438,0.292 10 false *f
*a From 1st Chamber of Master Cylinder Sub-assembly
*b From 2nd Chamber of Master Cylinder Sub-assembly
*c To Front Wheel Cylinder Assembly LH
*d To Rear Wheel Cylinder Assembly RH
*e To Rear Wheel Cylinder Assembly LH
*f To Front Wheel Cylinder Assembly RH


Using a union nut wrench, disconnect the 6 brake lines from the brake actuator assembly.


d.

Use tags or make a memo to identify the places to reconnect the lines.


e.
C239183

Remove the 3 bolts and brake actuator with bracket from the vehicle body.

NOTICE:

Do not damage the brake lines, suction hose sub-assembly or wire harness.



Hide 44510 5.REMOVE BRAKE ACTUATOR ASSEMBLY

a.
C238434

Loosen the 3 nuts and remove the brake actuator assembly from the brake actuator bracket assembly.