Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR
RM2030EQ _54 Brake _014650 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0074505 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.

·

If the sensor rotor needs to be replaced, replace the front drive outboard joint shaft assembly.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53876A 3.REMOVE FRONT FENDER LINER

HINT:

Use the same procedure for the LH side and RH side.

Click hereVehicle Exterior>WIPER / WASHER>WASHER MOTOR>REMOVAL


Hide 89543 4.REMOVE FRONT SPEED SENSOR

a.
C238451

Disconnect the connector and disengage the clamp.


b.
C238450

Remove the bolt and front speed sensor clamp from the body.


c.
C238449C03
1.479,0.323 2.344,0.323 true 1.083,1.01 0.74,1.823 true 2.385,0.26 2.76,0.594 0.375,0.333 10 false *1 0.646,1.854 1.01,2.135 0.365,0.281 10 false *2
*1 Front Speed Sensor Clamp
*2 Front Flexible Hose


Remove the bolt, front flexible hose and front speed sensor clamp together from the shock absorber assembly.


d.

Disengage the clamp from the front shock absorber assembly.


e.
C238448

Remove the bolt and front speed sensor from the steering knuckle.

NOTICE:
·

Prevent foreign matter from attaching to the front speed sensor tip.

·

Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.