Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE PEDAL LOAD SENSING SWITCH
RM2030EQ _54 Brake _014650 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0074508 BRAKE PEDAL LOAD SENSING SWITCH G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE PEDAL LOAD SENSING SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE PEDAL LOAD SENSING SWITCH

a.
C239141
1.531,2.073 0.979,2.823 true 1.854,2.063 2.406,2.823 true 0.271,0.229 0.823,0.615 0.552,0.385 10 *a 0.688,2.875 1.604,3.25 0.917,0.375 10 FSW+ 2.25,2.875 3.052,3.229 0.802,0.354 10 FSW-
*a Component without harness connected
(Brake Pedal Load Sensing Switch (Brake Pedal Support Assembly))


Make sure that there is no looseness in the locking part and the connecting part of the connector.


b.

Disconnect the brake pedal load sensing switch connector.


c.

Check both the connector case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion.


NOTICE:
·

Do not remove the brake pedal load sensing switch from the brake pedal support assembly.

·

When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal support assembly.




d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
2 (FSW+) - 1 (FSW-) Switch OFF (Brake pedal depressed) 950 to 1050 Ω
2 (FSW+) - 1 (FSW-) Switch ON (Brake pedal released) 203 to 223 Ω


If the result is not as specified, replace the brake pedal load sensing switch (brake pedal support assembly).