47731
1.REMOVE FRONT DISC BRAKE PISTON
for PBR Made:
Place a piece of cloth between the front disc brake piston and front disc brake cylinder assembly.
Apply compressed air to remove the front disc brake piston from the front disc brake cylinder assembly.
Do not place your fingers in front of the front disc brake piston when using compressed air.
Do not allow any brake fluid to spatter.
2.REMOVE CYLINDER BOOT
for PBR Made:
Remove the cylinder boot from the disc brake cylinder assembly.
for ADVICS Made:
| *1 | Vinyl Tape |
Using a screwdriver with its tip wrapped with vinyl tape, remove the front disc brake piston set ring and cylinder boot from the disc brake cylinder assembly.
Be careful not to damage the front disc brake piston or front disc brake cylinder.
47731
3.REMOVE FRONT DISC BRAKE PISTON
for ADVICS Made:
Place a piece of cloth between the front disc brake piston and front disc brake cylinder.
Apply compressed air to remove the front disc brake piston from the front disc brake cylinder.
Do not place your fingers in front of the front disc brake piston when using compressed air.
Do not allow any brake fluid to spatter.
4.REMOVE PISTON SEAL
| *1 | Vinyl Tape |
Using a screwdriver with its tip wrapped with vinyl tape, remove the piston seal from the front disc brake cylinder.
Do not damage the inner surface or piston seal groove of the front disc brake cylinder.
31478B
5.REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP
47547B
6.REMOVE FRONT DISC BRAKE BLEEDER PLUG