47547B
1.TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG
Fully tighten the front disc brake bleeder plug after bleeding.
31478B
2.INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP
3.INSTALL PISTON SEAL
Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal.
Install the piston seal to the front disc brake cylinder.
Securely install the piston seal to the groove of the front disc brake cylinder.
47731
4.INSTALL FRONT DISC BRAKE PISTON
for ADVICS Made:
| *1 | Cylinder Boot |
| *2 | Front Disc Brake Piston |
|
Lithium Soap Base Glycol Grease |
Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot.
Install the cylinder boot to the front disc brake piston.
Apply a light layer of lithium soap base glycol grease to the contact surfaces of the front disc brake piston, and install it to the front disc brake cylinder.
Do not install the front disc brake piston forcibly in the front disc brake cylinder.
5.INSTALL CYLINDER BOOT
for PBR Made:
| *1 | Cylinder Boot |
| *2 | Front Disc Brake Piston |
|
Lithium Soap Base Glycol Grease |
Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot and front disc brake piston.
Install the cylinder boot to the front disc brake piston.
for ADVICS Made:
| *1 | Front Disc Brake Piston Set Ring |
| *2 | Cylinder Boot |
Install the cylinder boot to the front disc brake cylinder.
Securely install the cylinder boot to the groove of the front disc brake cylinder and front disc brake piston.
| *1 | Vinyl Tape |
Using a screwdriver, install a new front disc brake piston set ring.
Securely install the front disc brake piston set ring to the outer groove of the cylinder boot.
Do not damage the cylinder boot.
47731
6.INSTALL FRONT DISC BRAKE PISTON
for PBR Made:
| *1 | Front Disc Brake Piston |
| *2 | Cylinder Boot |
Install the cylinder boot securely to the grooves of the front disc brake cylinder.
Securely install the cylinder boot into the groove of the disc brake cylinder and front disc brake piston.
Do not damage the cylinder boot.
Push in the front disc brake piston by hand and install the cylinder boot onto the grooves of the front disc brake piston.