Because the left and right rear flexible hoses are not interchangeable, verify the part number when installing the flexible hoses.
If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
47319F
1.INSTALL REAR FLEXIBLE HOSE
for PBR Made:
| *a | Lock Hole |
Connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and 2 new gaskets.
Install the flexible hose lock securely into the lock hole in the disc brake cylinder.
for ADVICS Made:
| *a | Lock Hole |
Connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.
Install the flexible hose lock securely into the lock hole in the disc brake cylinder.
Install the rear flexible hose with the bolt.
Install a new clip.
Install the clip as far as it will go.
Using a union nut wrench, connect the brake line to the rear flexible hose while holding the rear flexible hose with a wrench.
Do not bend or damage the brake line.
Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.
Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.BLEED BRAKE LINE
3.INSTALL REAR WHEEL