Home › Brake › PARKING BRAKE › PARKING BRAKE ASSEMBLY › 2012.02–2015.04
RM2030EQ _54 Brake _014654 PARKING BRAKE _0074526 PARKING BRAKE ASSEMBLY G

PARKING BRAKE  PARKING BRAKE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE DISC INSIDE DIAMETER

a.
C132647

Using a brake drum gauge or an equivalent tool, measure the inside diameter of the disc.

Diameter:
Standard inside diameter Maximum inside diameter
for PBR Made 190 mm (7.48 in.) 191 mm (7.51 in.)
for ADVICS Made 170 mm (6.69 in.) 171 mm (6.73 in.)


If the inside diameter is more than the maximum, replace the disc.


Hide 2.INSPECT PARKING BRAKE SHOE LINING THICKNESS

a.

for PBR Made:

i.
C138225

Using a ruler, measure the thickness of the parking brake shoe lining.

Standard thickness:

3.8 mm (0.150 in.)


Minimum thickness:

1.5 mm (0.0591 in.)



ii.
C141948

Using a ruler, measure the thickness variation within the 260° range as shown in the illustration.

Thickness variation within 260° range:

0.5 mm (0.0197 in.) or less.


If the lining thickness is less than the minimum, or if there is severe or uneven wear, replace the parking brake shoe.

NOTICE:

Always replace both the right and left parking brake shoes together.




b.

for ADVICS Made:

i.
C166158

Using a ruler, measure the thickness of the parking brake shoe lining.

Standard thickness:

2.0 mm (0.0787 in.)


Minimum thickness:

1.0 mm (0.0394 in.)


If the lining thickness is less than the minimum, or if there is severe or uneven wear, replace the parking brake shoe assembly.

HINT:

Always replace both right and left parking brake shoes together.




Hide 3.INSPECT BRAKE DISC AND PARKING BRAKE SHOE LINING FOR PROPER CONTACT

a.

for PBR Made:

i.
C138226

Apply chalk to the inside surface of the disc, then slide the brake shoe against the disc to check the fit of the brake shoe lining to the disc.

If the contact between the disc and the parking brake shoe lining is improper, repair it using a brake shoe grinder or replace the parking brake shoe.

NOTICE:

Wipe off the chalk after inspection.




b.

for ADVICS Made:

i.
C166159

Apply chalk to the inside surface of the disc, then slide the brake shoe against the disc to check the fit of the brake shoe lining to the disc. If the contact between the disc and the brake shoe lining is incorrect, repair it using a brake shoe grinder or replace the parking brake shoe assembly.

NOTICE:
·

Always replace both right and left parking brake shoes together.

·

Wipe off the chalk after inspection.