Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY › 2012.02–2015.04
RM2030EQ _55 Steering _014656 STEERING COLUMN _0074532 STEERING COLUMN ASSEMBLY G

STEERING COLUMN  STEERING COLUMN ASSEMBLY  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:

When using a vise, do not overtighten it.


PROCEDURE

Hide 1.INSPECT PRELOAD

a.
C236194C04
2.438,1.583 3.115,1.583 true 2.188,1.896 2.823,1.896 2.823,1.896 2.823,1.583 true 1.24,1.792 0.719,1.792 false 3.146,1.51 3.427,1.823 0.281,0.313 10 *1 0.552,1.708 0.823,1.979 0.271,0.271 10 *2
*1 Aluminum Plate
*2 Wooden Block


Secure the steering column assembly in a vice using aluminum plates as shown in the illustration.

NOTICE:
·

Do not overtighten the vice, as the steering column assembly may become deformed.

·

Support the steering column assembly with a wooden block or similar item to ensure that it does not fall.




b.
C220801C02
0.815,1.529 0.964,1.681 0.149,0.152 10 *1 1.585,1.264 1.585,1.617 1.585,1.617 0.991,1.617 false 1.401,1.34 1.401,1.617 false
*1 Service Nut


Install the 2 service nuts to the steering main shaft.

Recommended service nut:
Thread diameter:

12.0 mm (0.472 in.)

Thread pitch:

1.25 mm (0.0492 in.)



c.

Simultaneously rotate the service nut that was installed first counterclockwise and rotate the service nut that was installed second clockwise to lock them.

NOTICE:

Do not apply excess torque to the service nuts by using a tool such as an impact wrench.


HINT:

These nuts are installed to turn the steering main shaft. They should be removed after inspecting the steering main shaft rotating torque.



d.
C239329

Using a torque wrench, turn the main shaft and measure the preload.

Preload:

1.2 to 1.7 N*m (12 to 17 kgf*cm, 10 to 15 in.*lbf)


If the preload is not as specified, replace the electric power steering column sub-assembly with a new one.


Hide 2.INSPECT STEERING LOCK OPERATION (w/o Smart Entry and Start System)

a.
C239701

Check that the steering lock mechanism is activated when the key is removed.


b.
C239702
2.104,0.873 2.257,1.023 0.153,0.15 10 *a 1.835,0.317 1.998,0.462 0.163,0.145 10 *b
*a LOCK
*b ACC


Check that the steering lock mechanism is deactivated when the key is inserted and turned to the ACC position.

HINT:

If there is any abnormality, replace the ignition switch lock cylinder assembly or steering column upper bracket assembly.