Home › Steering › STEERING COLUMN › STEERING PAD SWITCH(for 3 Spoke) › 2012.02–2015.04
RM2030EQ _55 Steering _014656 STEERING COLUMN _0074536 STEERING PAD SWITCH(for 3 Spoke) G

STEERING COLUMN  STEERING PAD SWITCH(for 3 Spoke)  INSPECTION  


PROCEDURE

Hide 84250A 1.INSPECT STEERING PAD SWITCH ASSEMBLY

a.

Measure the resistance according to the value(s) in the table below.

E245198
0.134,0.108 0.346,0.266 0.211,0.158 10 *a 1.605,1.593 1.759,1.751 0.154,0.158 10 *b 2.026,1.593 2.179,1.751 0.154,0.158 10 *f 1.277,2.518 1.431,2.676 0.154,0.158 10 *h 2.796,0.907 3.100,1.065 0.304,0.158 10 EAU 2.936,1.089 3.240,1.247 0.304,0.158 10 AU3 3.517,0.815 3.225,1.097 false 3.415,0.815 3.124,0.965 false 4.05,0.907 4.354,1.065 0.304,0.158 10 AU1 3.91,1.089 4.214,1.247 0.304,0.158 10 AU2 3.619,0.815 3.911,1.097 false 3.721,0.815 4.012,0.965 false 1.862,2.587 1.44,2.587 false 2.976,2.238 3.129,2.396 0.154,0.158 10 *i 2.318,2.587 2.951,2.306 false 2.976,2.907 3.129,3.065 0.154,0.158 10 *j 2.137,2.619 2.951,2.98 false 5.764,2.518 6.260,2.676 0.496,0.158 10 *m (*A) 5.261,2.587 5.739,2.587 false 2.09,2.357 2.09,1.758 false 1.908,2.189 1.712,1.758 false 2.358,1.593 2.512,1.751 0.154,0.158 10 *d 2.208,2.158 2.39,1.758 false 5.483,1.981 5.636,2.139 0.154,0.158 10 *k 5.08,2.413 5.477,2.103 false 5.287,3.419 5.440,3.578 0.154,0.158 10 *l 5.052,2.812 5.318,3.397 false 1.605,3.462 1.759,3.620 0.154,0.158 10 *c 2.026,3.462 2.179,3.620 0.154,0.158 10 *g 2.09,2.812 2.09,3.439 false 1.978,3.008 1.712,3.439 false 2.428,3.462 2.582,3.620 0.154,0.158 10 *e 2.365,3.118 2.46,3.439 false 5.292,1.519 5.446,1.677 0.154,0.158 10 *n 5.029,2.137 5.292,1.661 false 2.356,1.273 2.510,1.431 0.154,0.158 10 *o 2.941,1.341 2.518,1.341 false 2.974,0.538 3.29,0.645 false 2.75,0.456 2.998,0.615 0.248,0.158 10 HO 3.532,0.639 3.583,0.246 false 3.273,0.23 3.431,0.635 false 3.479,0.108 3.783,0.266 0.304,0.158 10 -DP 3.134,0.089 3.438,0.247 0.304,0.158 10 +DP
*A w/ Voice Switch of Steering Pad Switch Assembly - -
*a Component without harness connected
(Steering Pad Switch Assembly)
*b Volume+
*c Volume- *d Back
*e MODE/HOLD *f Up
*g Down *h Left
*i Right *j Enter
*k Off hook *l On hook
*m Voice *n DISP
*o Terminal-A - -


Standard Resistance:
Tester Connection Condition Specified Condition
1 (HO) - Terminal-A Always Below 1 Ω
2 (+DP) - 3 (-DP) No switch pushed 1 MΩ or higher
DISP switch pushed Below 1 Ω
11 (AU1) - 8 (EAU) No switch pushed 95 to 105 kΩ
Up switch pushed Below 2.5 Ω
Down switch pushed 313 to 345 Ω
Volume+ switch pushed 950 to 1050 Ω
Volume- switch pushed 2955 to 3265 Ω
10 (AU2) - 8 (EAU) No switch pushed 95 to 105 kΩ
MODE/HOLD switch pushed Below 2.5 Ω
On hook switch pushed 313 to 345 Ω
Off hook switch pushed 950 to 1050 Ω
Voice switch pushed*1 2955 to 3265 Ω
9 (AU3) - 8 (EAU) No switch pushed 95 to 105 kΩ
Enter switch pushed Below 2.5 Ω
Back switch pushed 313 to 345 Ω
Right switch pushed 950 to 1050 Ω
Left switch pushed 2955 to 3265 Ω


*1: w/ Voice Switch of Steering Pad Switch Assembly

HINT:

If the result is not as specified, replace the steering pad switch assembly.



b.

Check the illumination.

E245199
0.158,0.123 0.376,0.272 0.218,0.149 10 *a 4.079,1.065 4.374,1.214 0.295,0.149 10 IL+2 3.132,0.223 3.389,0.372 0.258,0.149 10 -DP 3.737,0.854 4.04,1.098 false 3.514,0.835 3.279,0.376 false
*a Component without harness connected
(Steering Pad Switch Assembly)
- -


i.

Connect a battery positive (+) lead to terminal IL+2 and a negative (-) lead to terminal -DP of the steering pad switch assembly connector.


ii.

Check that the switch illumination comes on.

OK:

Steering pad switch illumination comes on.


HINT:

If the result is not as specified, replace the steering pad switch assembly.