Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER › 2012.02–2015.04
RM2030EQ _56 Audio / Visual / Telematics _014659 NAVIGATION / MULTI INFO DISPLAY _0074554 NAVIGATION RECEIVER A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION RECEIVER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

A hard disk drive (HDD) is built into the navigation receiver assembly to store map and other data and is used for the navigation system. Therefore, make sure to read all of the precautions thoroughly before handling the navigation receiver assembly.

·

When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.



Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53922B 3.REMOVE FRONT PANEL GARNISH LH

Hide 53921B 4.REMOVE FRONT PANEL GARNISH RH

Hide 55405B 5.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 55660 6.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 58831A 7.REMOVE FRONT CONSOLE UPPER PANEL GARNISH

Hide 8.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY

a.
E227929C01
2.688,0.802 2.938,0.531 true 3,0.396 3.313,0.552 0.313,0.156 10 false *1
*1 Protective Tape


Apply protective tape to the area shown in the illustration.


b.
E227931

Remove the 4 bolts.


c.
E227933

Pull the navigation receiver assembly with air conditioning control assembly toward the rear of the vehicle and disengage the 6 clips.


d.

Disconnect each connector and remove the navigation receiver assembly with air conditioning control assembly.


Hide 86211J 9.REMOVE NO. 1 RADIO RECEIVER BRACKET

a.
E227936

Remove the 5 screws and No. 1 radio receiver bracket.


Hide 86212C 10.REMOVE NO. 2 RADIO RECEIVER BRACKET

a.
E230759

Remove the 5 screws and No. 2 radio receiver bracket.


Hide 55900 11.REMOVE AIR CONDITIONING CONTROL ASSEMBLY

Hide 13.REMOVE NAVIGATION ECU SUB-ASSEMBLY