GENERAL
The blind spot monitor is a system that assists the driver in making the decision to change lanes. The system uses quasi-millimeter wave radar to detect vehicles that are traveling in an adjacent lane in the area that is not reflected in the mirror sub-assembly. The system advises the driver of the existence of a vehicle by illuminating the blind spot monitor indicator on the mirror sub-assembly.
If the turn signal is operated while the blind spot monitor indicator on a mirror sub-assembly is illuminated, the indicator starts blinking to give additional warning to the driver.
FUNCTION OF COMPONENTS
| Component | Function |
|---|---|
| Blind Spot Monitor Sensor | ·
Consists of a 24 GHz radar module and an integrated processing module. ·
Illuminates the outer rear view mirror indicator on the mirror sub-assembly when a vehicle is present in the blind spot area. ·
Changes the outer rear view mirror indicator on the mirror sub-assembly from illuminated to blinking when a turn signal is received from the combination meter assembly. |
| Outer Rear View Mirror Indicator | Turns on or blinks the indicator based on a signal from the blind spot monitor sensor. |
| Outer Mirror Control ECU Assembly | Receives a signal from the blind spot monitor sensor and sends the signal to the outer rear view mirror indicator. |
| Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly) | Turns the blind spot monitor on or off. |
| Combination Meter Assembly | ·
Sends a turn signal state signal from the headlight dimmer switch assembly (turn signal light switch) to the blind spot monitor sensor via CAN communication. ·
Displays an error message on the multi-information display if the blind spot monitor detects a malfunction while it is operating. |
| Main Body ECU
(Multiplex Network Body ECU) |
Sends the destination information to the blind spot monitor sensor via CAN communication. |
| Brake Actuator Assembly
(Skid Control ECU) |
Transmits a vehicle speed signal to the blind spot monitor sensor via CAN Communication. |
| ECM | Sends shift position signal (R) and HV flag to the blind spot monitor sensor via CAN communication. |
| Steering Sensor | Detects the angle of the steering wheel and sends the resulting signals to the blind spot monitor sensor via CAN communication. |
OPERATION DESCRIPTION
Operation conditions of the blind spot monitor system
The blind spot monitor main switch (warning canceling switch assembly) is on.
Vehicle speed is more than approximately 40 km/h (25 mph).
Conditions in which a sensor can detect a vehicle
The blind spot monitor system indicates detection of a vehicle in the detection area when either condition is met:
When a vehicle is detected in an adjacent lane overtaking this vehicle.
When another vehicle is detected entering the detection area because it changed lanes.
| *a | Within approx. 3.5 m (11.49 ft) from the side of the vehicle |
| *b | Within approx. 3 m (9.85 ft) behind the rear bumper |
| *c | Within approx. 1 m (3.29 ft) forward of the rear bumper |
Detection area
Vehicles in the following areas can be detected:
OPERATION OF OUTER REAR VIEW MIRROR INDICATOR ON MIRROR SUB-ASSEMBLY
The outer rear view mirror indicator on each mirror sub-assembly operates as follows:
When the blind spot monitor main switch (warning canceling switch assembly) is turned on, the outer rear view mirror indicator on each mirror sub-assembly illuminates for 3 seconds (initial check).
While the system is operating, when a sensor detects a vehicle in the blind spot area, the outer rear view mirror indicator on the mirror sub-assembly illuminates.
While the system is detecting a vehicle in the detection area and the indicator is illuminated, if the turn signal is turned on, the indicator starts blinking.