Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH
RM2030EQ _56 Audio / Visual / Telematics _014660 PARK ASSIST / MONITORING _0074567 CLEARANCE SONAR MAIN SWITCH A

PARK ASSIST / MONITORING  CLEARANCE SONAR MAIN SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION (for RHD)

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for RHD)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 62312B 3.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

Hide 55318C 4.REMOVE INSTRUMENT SIDE PANEL

Hide 55650 5.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55431B 6.REMOVE UPPER INSTRUMENT PANEL FINISH PANEL (for RHD)

Hide 55410C 7.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 84490A 8.REMOVE BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY

a.

for LHD:

i.
E244901

Disengage the 2 claws and remove the back sonar or clearance sonar switch assembly.



b.

for RHD:

i.
E244902

Disengage the 2 claws and remove the back sonar or clearance sonar switch assembly.