Home › Power Source / Network › POWER DISTRIBUTION › INTEGRATION RELAY
RM2030EQ _57 Power Source / Network _014662 POWER DISTRIBUTION _0074572 INTEGRATION RELAY A

POWER DISTRIBUTION  INTEGRATION RELAY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 82662A 3.REMOVE NO. 1 RELAY BLOCK COVER

a.
B279031

Disengage the 2 claws and remove the No. 1 relay block cover as shown in the illustration.


Hide 82720 4.REMOVE ENGINE ROOM JUNCTION BLOCK ASSEMBLY

a.

Disengage the 2 claws as shown in the illustration.

B279033C05
5.698,1.333 6.531,1.448 true 6.323,2.5 6.146,2.552 false 6.583,1.385 6.875,1.594 0.292,0.208 10 false *1 6,2.458 6.271,2.708 0.271,0.25 10 false *a
*1 Protective Tape - -
*a Pulled Position - -



b.

Using pliers, pull up the engine room junction block assembly at the position indicated in the illustration and disconnect the 4 connectors from the engine room relay block assembly.

NOTICE:

When pulling the engine room junction block assembly, take care not to damage it.


HINT:

Tape the pliers tip before use.



c.
B282874

Disconnect the 2 connectors and remove the engine room junction block assembly.

NOTICE:
·

Do not drop or allow any impact on parts.

·

Do not touch the connector.