The key unlock warning switch assembly comes on when the ignition key is inserted into the ignition key cylinder and goes off when the ignition key is removed.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Key Unlock Warning SW | Unlock warning switch | ON or OFF | ON: Key is inserted into ignition key cylinder
OFF: Key is removed from ignition key cylinder |
- |
| Tester Display |
|---|
| Key Unlock Warning SW |
When the key is in the ignition key cylinder, "ON" appears on the screen.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>PROBLEM SYMPTOMS TABLE
NG
| *1 | Free (key removed) |
| *2 | Pushed (key set) |
| *a | Component without harness connected
(Unlock Warning Switch Assembly) |
Remove the unlock warning switch assembly.
Click hereVehicle Interior>DOOR LOCK>UNLOCK WARNING SWITCH>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Free
(Key removed) |
10 kΩ or higher |
| 1 - 2 | Pushed
(Key set) |
Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I13-17 (KSW) - I33-1 | Always | Below 1 Ω |
| I13-17 (KSW) - Body ground | Always | 10 kΩ or higher |
| I33-2 - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG