When the certification ECU (smart key ECU assembly) detects an input signal indicating that the vehicle is equipped with an ID code box even though the ID code box is not registered, the certification ECU (smart key ECU assembly) stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B278D | Malfunction of ID-BOX Recognition | One of the following conditions is met:
·
The certification ECU (smart key ECU assembly) recognizes that the wire harness judging whether the vehicle is equipped with an ID code box or not is provided even though the ID code box is not registered. ·
The certification ECU (smart key ECU assembly) receives a LIN signal from the ID code box even though the ID code box is not registered. ·
The certification ECU (smart key ECU assembly) receives a LIN signal from the ID code box even though the wire harness judging whether the vehicle is equipped with an ID code box or not is not provided. |
Misconnection of the ID code box | DTC Output Confirmation Operation
Always |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Key registration will be prohibited | - |
| DTC Code | Data List and Active Test |
|---|---|
| B278D | - |
Before performing the following inspection procedure, check that the ID code box (immobiliser code ECU) is not installed on the vehicle.
Before replacing the certification ECU (smart key ECU assembly), refer to the Service Bulletin.
After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
DTC B278D is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG