Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System) › 2012.02–2015.04
RM2030EQ _58 Vehicle Interior _014665 THEFT DETERRENT / KEYLESS ENTRY _0074602 ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System) C

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System)  B2793  Transponder Chip Malfunction  B2794  Unmatched Encryption Code  B2795  Unmatched Key Code  B2796  No Communication in Immobiliser System  B2797  Communication Malfunction No. 1  B2798  Communication Malfunction No. 2  


DESCRIPTION

·

DTC B2793 is stored when a malfunction is found in the key during key code registration or a key code is not registered normally. Replace the key if key code registration cannot be performed normally and this DTC is output.

·

DTC B2794 is stored when a key with an incomplete key code is inserted into the ignition key cylinder.

·

DTC B2795 is stored when a key with a key code that is not registered in the ECU is inserted into the ignition key cylinder.

·

DTC B2796 is stored when a key is inserted into the ignition key cylinder but no communication occurs between the key and transponder key ECU assembly.

·

DTC B2797 is stored when a key with a BCC malfunction is inserted into the ignition key cylinder.

·

DTC B2798 is stored when a key is inserted into the ignition key cylinder but a communication error occurs between the key and transponder key ECU assembly.


DTC No. Detection Item DTC Detection Condition Trouble Area
B2793 Transponder Chip Malfunction A transponder chip malfunction. Key
B2794 Unmatched Encryption Code A key with an incomplete key code is inserted into the ignition key cylinder. Key
B2795 Unmatched Key Code A key with an unregistered key code is inserted into the ignition key cylinder. Key
B2796 No Communication in Immobiliser System The key code cannot be transmitted. Key
B2797 Communication Malfunction No. 1 A key with a BCC malfunction is inserted into the ignition key cylinder. Key
B2798 Communication Malfunction No. 2 Key code identification cannot be completed within the specified time. Key

CAUTION / NOTICE / HINT

NOTICE:

If the transponder key ECU assembly or key is replaced, refer to Service Bulletin.


PROCEDURE

1.CLEAR DTC
a.

Result:
Proceed to
NEXT



NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT
a.

Check for DTCs using all registered keys.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System)>DTC CHECK / CLEAR

Body Electrical > Immobiliser > Trouble Codes
50001 260
HINT:

If a DTC is stored, check for DTCs with the next key after clearing the DTCs.


OK:

DTC B2793, B2794, B2795, B2796, B2797 and B2798 is not output.


Result:
Result Proceed to
OK A
NG (all keys) B
NG (any key) C




A

B

REPLACE TRANSPONDER KEY ECU ASSEMBLY

C

REPLACE KEY THAT STORED DTC