Home › Vehicle Interior › LIGHTING (INT) › REAR DOOR COURTESY SWITCH
RM2030EQ _58 Vehicle Interior _014666 LIGHTING (INT) _0074610 REAR DOOR COURTESY SWITCH A

LIGHTING (INT)  REAR DOOR COURTESY SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 84234 1.INSTALL REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY

a.

Using a T30 "TORX" socket wrench, install the rear door courtesy light switch assembly with the screw.

Torque:
6.3 N*m (64 kgf*cm, 56 in.*lbf)

HINT:

There are 2 diameters for the "TORX" screws: 6 mm (0.236 in.) and 7 mm (0.276 in.). The diameter of a supplied "TORX" screw is 7 mm (0.276 in.).



b.

Connect the connector.


Hide 2.INSTALL REAR SIDE SEATBACK ASSEMBLY

Hide 72693 3.INSTALL REAR SEAT CUSHION LOCK HOOK

Hide 4.INSTALL REAR SEAT CUSHION ASSEMBLY