Home › Vehicle Interior › LIGHTING (INT) › BACK DOOR COURTESY SWITCH
RM2030EQ _58 Vehicle Interior _014666 LIGHTING (INT) _0074611 BACK DOOR COURTESY SWITCH G

LIGHTING (INT)  BACK DOOR COURTESY SWITCH  INSPECTION  


PROCEDURE

Hide 64610 1.INSPECT LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY

a.

Check the operation of the door lock motor.

i.
B285028
0.685,0.515 0.845,0.678 0.161,0.163 10 *b 0.094,0.074 0.255,0.237 0.161,0.163 10 *a 2.128,0.515 2.289,0.678 0.161,0.163 10 *c 2.754,1.49 2.754,1.784 2.754,1.784 2.679,1.784 false 2.525,1.699 2.64,1.846 0.115,0.147 10 E 3.002,1.699 3.116,1.84 0.113,0.141 10 B 2.888,1.49 2.888,1.784 2.888,1.784 2.964,1.784 false
*a Component without harness connected
(Luggage Compartment Door Lock Assembly)
*b Close (Lock)
*c Open (Unlock)


Move the door lock to the close (lock) position.


ii.

Apply battery voltage to the door lock motor and check operation of the door lock motor.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 1 (B)
Battery negative (-) → 2 (E)
Luggage compartment door lock motor open (unlock) operation


If the result is not as specified, replace the luggage compartment door lock assembly.



b.

Check the operation of the door courtesy switch.

i.
B285028
0.685,0.515 0.845,0.678 0.161,0.163 10 *b 0.094,0.074 0.255,0.237 0.161,0.163 10 *a 2.128,0.515 2.289,0.678 0.161,0.163 10 *c 2.634,1.49 2.634,1.784 2.634,1.784 2.558,1.784 false 2.319,1.699 2.526,1.846 0.207,0.147 10 D+ 2.852,1.699 2.966,1.846 0.115,0.147 10 E 2.751,1.49 2.751,1.784 2.751,1.784 2.826,1.784 false
*a Component without harness connected
(Luggage Compartment Door Lock Assembly)
*b Close (Lock)
*c Open (Unlock)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Measurement Condition Door Lock Condition Specified Condition
2 (E) - 3 (D+) Close (Lock) 10 kΩ or higher
2 (E) - 3 (D+) Open (Unlock) Below 1 Ω


If the result is not as specified, replace the luggage compartment door lock assembly.