DATA LIST
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus:
for Combination Meter: Body / Combination Meter / Data List.
for ABS/VSC/TRC: Chassis / ABS/VSC/TRC / Data List.
for Engine and ECT: Powertrain / Engine and ECT / Data List.
for Main Body: Body / Main Body / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Tail Relay SW | Tail relay | OFF or ON | OFF: Tail relay off
ON: Tail relay on |
- |
| ODO/TRIP Change SW | ODO/TRIP change switch | OFF or ON | OFF: Switch released
ON: Switch pushed |
- |
| P-Seatbelt Buckle SW | Front passenger seat belt buckle switch | OFF or ON | OFF: Front passenger seat belt fastened (warning light off)
ON: Front passenger seat belt unfastened (warning light on) |
- |
| Vehicle Speed Meter | Vehicle speed | Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) | Almost the same as actual vehicle speed | - |
| Engine Rpm | Engine speed | Min.: 0 rpm, Max.: 12750 rpm | 600 to 700 rpm: Idling | - |
| Coolant Temperature | Engine coolant temperature | -40 to 127.5°C (-40 to 261.5°F) | After warming up: 75 to 100°C (167 to 212°F) | ·
After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F). ·
After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature are approximately equal. ·
If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit is open or shorted. ·
Check if the engine overheats when the value indicates higher than 135°C (275°F). |
| Light Control Switch | Light control switch | OFF or ON | OFF: Light control switch off
ON: Light control switch not off |
- |
| Multi Display Select Switch | DISP switch in the steering pad switch assembly | OFF or ON | OFF: DISP switch in the steering pad switch assembly not pressed
ON: DISP switch in the steering pad switch assembly pressed |
- |
| +B Voltage Value | Battery voltage | Min.: 0 V, Max.: 25.5 V | 11 to 14 V | - |
| Fuel Input | Fuel input | Min.: 0, Max.: 127.5 | Fuel receiver gauge indicates F: 62.9
Fuel receiver gauge indicates 3/4: 54.5 Fuel receiver gauge indicates 1/2: 35.0 Fuel receiver gauge indicates 1/4: 15.4 Fuel receiver gauge indicates E: 7.0 |
Unit: Liter |
| Ambient Temperature | Outside temperatur | Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F) | Almost the same as actual outside temperature | The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F) |
| 2nd-Row Seatbelt Buckle (R) | Rear seat belt buckle switch RH | OFF or ON | ON: Rear seat belt RH unfastened
OFF: Rear seat belt RH fastened |
*1 |
| 2nd-Row Seatbelt Buckle (L) | Rear seat belt buckle switch LH | OFF or ON | ON: Rear seat belt LH unfastened
OFF: Rear seat belt LH fastened |
*1 |
| 2nd-Row Seatbelt Buckle (C) | Rear seat belt buckle switch center | OFF or ON | ON: Rear seat belt center unfastened
OFF: Rear seat belt center fastened |
*1 |
| Oil Pressure Switch | Oil pressure switch | OFF or ON | OFF: Engine started
ON: Engine not started |
- |
| Turn Signal Switch (Right) | RH turn signal switch | OFF or ON | OFF: RH turn signal switch off
ON: RH turn signal switch on |
- |
| Turn Signal Switch (Left) | LH turn signal switch | OFF or ON | OFF: LH turn signal switch off
ON: LH turn signal switch on |
- |
| Hazard Flasher Switch | Hazard warning switch | OFF or ON | OFF: Switch released
ON: Switch pushed |
- |
| Headlight Auto Leveling Switch | Automatic headlight beam level control condition | OFF or ON | OFF: Automatic headlight beam level control is off
ON: Automatic headlight beam level control is on |
Not applicable
*2 |
| Key Remind Sound | Cycle of the key reminder warning buzzer | Normal, Slow, Fast | The cycle of the key reminder warning buzzer/Normal, Slow, Fast | - |
| Driver Side Seatbelt Warning Buzzer | Condition of the seat belt warning buzzer | OFF or ON | OFF: The seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the driver seat belt unfastened
ON: The seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the driver seat belt unfastened |
Displays customize setting of seat belt warning buzzer |
| P-Seatbelt Warning Buzzer | Condition of the seat belt warning buzzer | OFF or ON | OFF: The seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the front passenger seat belt unfastened
ON: The seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the front passenger seat belt unfastened |
Displays customize setting of seat belt warning buzzer |
| Rear Seatbelt Warning Buzzer | Condition of the rear seat belt warning buzzer | OFF or ON | OFF: The rear seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the rear seat belt unfastened
ON: The rear seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the rear seat belt unfastened |
Displays customize setting of rear seat belt warning buzzer |
| Number of Trouble Code | The number of the DTCs currently stored | 0 to 255 | 0 | - |
*1: for RHD
*2: w/ Automatic Headlight Beam Level Control System
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Vehicle Speed | Maximum wheel speed sensor reading | Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Engine Speed | Engine speed | Min.: 0 rpm, Max.: 16383 rpm | 600 to 700 rpm: Idling
Results of real-vehicle check: Idling (warm up the engine and A/C off): 660 rpm |
·
Stored as Freeze Frame Data ·
When the crankshaft position sensor is malfunctioning, "Engine Speed" is approximately 0 rpm or varies greatly from the actual engine speed. |
| Coolant Temp | Coolant temperature | Min.: -40°C (-40°F), Max.: 140°C (284°F) | 75 to 100°C (167 to 212°F): After warming up | ·
Stored as Freeze Frame Data ·
This is the engine coolant temperature. |
| Injection Volum (Cylinder1) | Injection volume (cylinder 1) | Min.: 0 ml, Max.: 2.047 ml | 0 to 0.5 ml
Results of real-vehicle check: ·
Idling (engine warmed up): 0.108 ml ·
Running without load (3000 rpm): 0.097 ml |
·
Stored as Freeze Frame Data ·
This is the fuel injection volume for 10 injections. |
After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).
After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature are approximately equal.
If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit is open or shorted.
Check if the engine overheats when the value indicates higher than 135°C (275°F).
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Illumination Rate Info | Illumination rate information | 0 ms. to 2162.65 ms. | Value output according to ambient light level | - |
ACTIVE TEST
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Active Test.
Check the operation by referring to the table below.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Speed Meter Operation | Speedometer | 0, 40, 80, 120, 160, 200, 240 km/h | - |
| TachoMeter Operation | Tachometer | 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 (rpm) | - |
| Fuel Meter Operation | Fuel receiver gauge | EMPTY, 1/2, FULL | - |
| Fuel Consumption Meter Operation | Fuel consumption meter | OFF, MIN., 1/4, 1/2, 3/4, MAX. | - |
| A/T Indicator Operation 1 | Shift indicator (P, R, N, D, 4, 3, 2, L) | OFF or ON | - |
| A/T Indicator Operation 2 | Shift indicator (S, 6, 5) | OFF or ON | - |
| A/T Indicator Operation 3 | Shift indicator (D) (sport mode) | OFF or ON | - |
| Indicat. Lamp Airbag | SRS warning light | OFF or ON | - |
| Indicat. Lamp Doors All Open | Door indicator light | OFF or ON | - |
| Driver Side Seat Belt | Seat belt warning light | OFF or ON | - |
| Indicat. Lamp ABS | ABS warning light | OFF or ON | - |
| Indicat. Lamp Charge | Charge warning light | OFF or ON | - |
| Indicat. Lamp Slip | Slip indicator light | OFF or ON | - |
| Indicat. Lamp Beam | High beam indicator light | OFF or ON | - |
| Indicat. Lamp Tail | Tail indicator light | OFF or ON | - |
| Indicat. Lamp Fr FOG | Front fog indicator light | OFF or ON | *1 |
| Indicat. AFS | AFS OFF indicator light | OFF or ON | *10 |
| Indicat. Lamp Fuel | Fuel level warning light | OFF or ON | - |
| Indicat. Oil Pressure | Oil pressure warning light | OFF or ON | - |
| Indicat. ECONO | ECO indicator light | OFF or ON | - |
| Indicat. Lamp Cruise | Cruise control indicator light (green) | OFF or ON | - |
| Indicat. Lamp Brake | Brake warning light | OFF or ON | - |
| Indicat. EPS | EPS warning light | OFF or ON | - |
| Indicat. Over Speed | Speed limit warning light | OFF or ON | *2 |
| Indicat. SET | SET indicator light | OFF or ON | - |
| Rear Seat Belt | Rear seat belt reminder light | OFF or ON | *3 |
| Cruise Indicator | Cruise control indicator light (amber) | OFF or ON | *4, *8 |
| Turn Signal (Left) Indicator | LH turn indicator light | OFF or ON | - |
| Turn Signal (Right) Indicator | RH turn indicator light | OFF or ON | - |
| Smart System Indicator | Smart entry and start system warning light (green) | OFF or ON | *5 |
| Smart System Warning | Smart entry and start system warning light (orange) | OFF or ON | *4, *5, *9 |
| Automatic High Beam Indicator | Automatic high beam indicator light | OFF or ON | *6 |
| Blind Spot Monitor Indicator | Blind spot monitor indicator light | OFF or ON | *7 |
| Water Temperature Meter Operation | Engine coolant temperature receiver gauge | Low, Normal, High | - |
| Meter Display 1 | All segment in the ODO/TRIP meter | OFF, 0, 1, 2, 3, 4, 5, 6, All | - |
| Meter Display 2 | All segment in the ODO/TRIP meter | OFF, 7, 8, 9 | - |
*1: w/ Front Fog Light
*2: for LHD
*3: for RHD
*4: Although the item is displayed on the intelligent tester, no warning light or indicator light is operated.
*5: w/ Smart Entry and Start System
*6: w/ Automatic High Beam System
*7: w/ Blind Spot Monitor System
*8: The cruise control indicator light (amber) can be operated by selecting this item.
*9: The smart entry and start system warning light (orange) can be operated by selecting this item.
*10: w/ AFS (Adaptive Front-lighting System)