Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD › 2012.02–2015.04
RM2030EQ _58 Vehicle Interior _014669 SUPPLEMENTAL RESTRAINT SYSTEMS _0074621 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the 3 spoke and 4 spoke.

·

The procedure listed below is for the 3 spoke.



PROCEDURE

Hide 45130 1.INSTALL HORN BUTTON ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B289015C01
0.458,2.094 1.573,2.094 true 2.313,2.448 2.313,2.885 2.313,2.885 2.51,2.885 true 0.969,0.302 0.854,0.198 0.854,0.198 0.708,0.198 true 0.271,2 0.469,2.198 0.198,0.198 10 false *1 2.563,2.813 2.771,3.01 0.208,0.198 10 true *2 0.521,0.125 0.708,0.302 0.188,0.177 10 false *3
*1 Airbag Connector
*2 Horn Connector
*3 Airbag Connector Lock


Connect the airbag connector to the horn button assembly.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



d.

Push in the lock to install the airbag connector.


e.

Connect the horn connector to the horn button assembly.


f.
B289016

Push the horn button assembly to engage the 3 pins carefully.

NOTICE:
·

Make sure that the pins are securely inserted into the steering holes.

·

Make sure to engage the 2 upper pins first.

·

Make sure that the horn button assembly is securely installed.




Hide 45187 2.INSTALL LOWER NO. 3 STEERING WHEEL COVER

a.

Engage the claw and guide to install the lower No. 3 steering wheel cover.


Hide 45186 3.INSTALL LOWER NO. 2 STEERING WHEEL COVER

a.

Engage the claw and guide to install the lower No. 2 steering wheel cover.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 45130 5.INSPECT HORN BUTTON ASSEMBLY

a.

Make sure that the horn sounds.

HINT:

If the horn does not sound, inspect the horn system (See page Vehicle Exterior>HORN>HORN SYSTEM>PROBLEM SYMPTOMS TABLE).