Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY
RM2030EQ _58 Vehicle Interior _014669 SUPPLEMENTAL RESTRAINT SYSTEMS _0074624 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 55011A 2.REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Hide 82142A 3.DISCONNECT NO. 2 INSTRUMENT PANEL WIRE

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B288991C04
0.688,2.729 0.688,2.99 0.688,2.99 2.146,2.99 false 1.844,2.74 1.844,2.99 false 2.188,2.896 2.438,3.135 0.25,0.24 10 false *a
*a Slider


Slide the slider to release the lock, and then disconnect the connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.



Hide 4.REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY

Hide 73960A 5.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

CAUTION:

When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.


a.
B282215

Remove the 2 screws.


b.
B282217

Lean the instrument panel safety pad assembly and disengage the 3 hooks.


c.
B282218

Disengage the 3 hooks to remove the instrument panel passenger airbag assembly from the instrument panel safety pad assembly.


Hide 82142A 6.REMOVE NO. 2 INSTRUMENT PANEL WIRE

a.
B282219C03
1.26,0.74 1.115,0.583 1.115,0.583 0.521,0.583 false 1.448,0.635 1.646,0.427 1.646,0.427 1.948,0.427 false 2.583,2.24 2.479,2.146 2.479,2.146 2.198,2.146 false 0.344,0.5 0.604,0.74 0.26,0.24 10 false *1 2,0.354 2.313,0.615 0.313,0.26 10 false *2 2.021,2.063 2.292,2.313 0.271,0.25 10 false *3
*1 Protective Tape
*2 Airbag Connector
*3 Airbag Connector Lock


Disengage the clamp.


b.

Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock.


c.

Disconnect the airbag connector to remove the No. 2 instrument panel wire from the instrument panel passenger airbag assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.