Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
89860C
1.INSTALL SIDE NO. 2 AIRBAG SENSOR ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Before connecting the connector, check that the position of the white housing lock is correct as shown in the illustration.
| *a | Incorrect | *b | Correct |
Insert the pin (stopper) into the body hole and install the side No. 2 airbag sensor assembly to the vehicle body with the bolt.
If the side No. 2 airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
When installing the side No. 2 airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
Make sure that the pin (stopper) is securely inserted into the body hole.
Tighten the bolt while holding the side No. 2 airbag sensor assembly because the side No. 2 airbag sensor assembly pin (stopper) is easily damaged.
Connect the connector to the side No. 2 airbag sensor assembly.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Be sure to engage the connectors until they are locked (when locking, make sure that a click sound can be heard).
| *1 | White Housing Lock | *2 | Yellow CPA |
| *a | Connection is Completed | - | - |
When engaged, the white housing lock will slide. Be sure not to hold the white housing lock or part (A), as it may result in an insecure fit.
Check that there is no looseness in the installation parts of the side No. 2 airbag sensor assembly.
2.INSTALL REAR SIDE SEATBACK ASSEMBLY
72693
3.INSTALL REAR SEAT CUSHION LOCK HOOK
4.INSTALL REAR SEAT CUSHION ASSEMBLY
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
6. PERFORM DIAGNOSTIC SYSTEM CHECK
7.INSPECT SRS WARNING LIGHT