1.INSTALL FRONT SEAT ASSEMBLY
Place the front seat assembly in the cabin.
Be careful not to damage the vehicle body.
Connect each connector and clamp under the seat.
Temporarily install the front seat assembly with the 4 bolts.
Lift up the seat track adjusting handle and move the seat to the rearmost position.
Tighten the 2 bolts on the front side of the seat.
Tighten the bolts in the order indicated in the illustration.
Lift up the seat track adjusting handle and move the seat to the foremost position.
Tighten the 2 bolts on the rear side of the seat.
Tighten the bolts in the order indicated in the illustration.
2.INSPECT SEAT SLIDE ADJUSTER LOCKS
During the sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously. If the seat adjusters do not lock simultaneously, loosen the seat installation bolts to adjust the adjuster position.
72157C
3.INSTALL REAR INNER SEAT TRACK BRACKET COVER
Lift up the seat track adjusting handle and move the seat to the foremost position.
Engage the 2 claws to install the rear inner seat track bracket cover.
72137J
4.INSTALL REAR OUTER SEAT TRACK BRACKET COVER
Engage the 2 claws to install the rear outer seat track bracket cover.
71910A
5.INSTALL FRONT SEAT HEADREST ASSEMBLY
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
7.INSPECT SRS WARNING LIGHT