Home › Vehicle Interior › SEAT BELT › REAR SEAT INNER BELT ASSEMBLY › 2012.02–2016.05
RM2030EQ _58 Vehicle Interior _014671 SEAT BELT _0074647 REAR SEAT INNER BELT ASSEMBLY G

SEAT BELT  REAR SEAT INNER BELT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 73480 1.INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH

a.

Check the ELR function.

i.
B279526C13
2.229,0.313 2.927,0.604 2.927,0.604 2.313,1.01 false 0.552,0.656 0.771,0.885 0.219,0.229 10 false *a 2.969,0.521 3.26,0.729 0.292,0.208 10 false *1 1.344,1.99 1.583,2.177 0.24,0.188 10 false *b 0.896,1.365 1.135,1.542 0.24,0.177 10 false *c
*1 Retractor
*a Unlocked
*b Locked
*c 45°


Before installing the rear seat inner with center belt assembly LH, check the ELR function.

NOTICE:

Do not disassemble the retractor.



ii.

When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.

If the result is not as specified, replace the rear seat inner with center belt assembly LH.



b.

Check the buckle switch. (for RHD)

i.
B161051C32
0.115,0.073 0.458,0.354 0.344,0.281 10 false *a
*a Component without harness connected
(Rear Seat Inner with Center Belt Assembly LH)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Rear LH seat belt not fastened Below 1 Ω
1 - 2 Rear LH seat belt fastened 10 kΩ or higher


If the result is not as specified, replace the rear seat inner with center belt assembly LH.



Hide 73470B 2.INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH (for RHD)

a.

Inspect the rear seat inner with center belt assembly RH (for RH).

i.
B161051C32
0.115,0.073 0.458,0.354 0.344,0.281 10 false *a
*a Component without harness connected
(Rear Seat Inner with Center Belt Assembly RH (for RH))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Rear RH seat belt not fastened Below 1 Ω
1 - 2 Rear RH seat belt fastened 10 kΩ or higher


If the result is not as specified, replace the rear seat inner with center belt assembly RH.



b.

Inspect the rear seat inner with center belt assembly RH (for center).

i.
B273021C01
0.167,0.135 0.51,0.375 0.344,0.24 10 false *a
*a Component without harness connected
(Rear Seat Inner with Center Belt Assembly RH (for center))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Rear center seat belt not fastened Below 1 Ω
1 - 2 Rear center seat belt fastened 10 kΩ or higher


If the result is not as specified, replace the rear seat inner with center belt assembly RH.