Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR
RM2030EQ _58 Vehicle Interior _014672 HEATING / AIR CONDITIONING _0074661 FRONT EVAPORATOR TEMPERATURE SENSOR A

HEATING / AIR CONDITIONING  FRONT EVAPORATOR TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 88625 1.INSTALL NO. 1 COOLER THERMISTOR

a.
E151029
1.656,0.354 1.979,0.354 1.979,0.354 2.24,0.833 false 2.573,0.854 2.75,0.74 false 2,3.208 2.104,2.156 false 2.656,3.198 2.302,2.156 false 1.396,1.5 1.688,1.75 0.292,0.25 10 false A 1.406,1.771 1.74,2.021 0.333,0.25 10 false B 1.25,2.396 1.646,2.656 0.396,0.26 10 false C 2.333,0.104 2.563,0.344 0.229,0.24 10 false X 1.531,0.25 1.781,0.521 0.25,0.271 10 false a 2.771,0.625 3.052,0.844 0.281,0.219 10 false b 2.625,3.208 2.948,3.406 0.323,0.198 10 false *b 1.906,3.198 2.302,3.417 0.396,0.219 10 false *a
*a Fixed Part
*b Sensor Part


Install the No. 1 cooler thermistor as shown in the illustration.

Part Length
A 34.3 mm 1.35 in.
B 20.9 mm 0.82 in.
C 50 mm 1.96 in.

NOTICE:
·

Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.

·

When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (X in the illustration).

·

After inserting the thermistor, do not apply excessive force to the wire.

·

Directly insert the thermistor until the edge of plastic case "a" comes into contact with evaporator "b".




b.

Engage the 2 clamps.


Hide 2.INSTALL BLOWER ASSEMBLY WITH COOLER EVAPORATOR SUB-ASSEMBLY