Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR
RM2030EQ _58 Vehicle Interior _014672 HEATING / AIR CONDITIONING _0074661 FRONT EVAPORATOR TEMPERATURE SENSOR G

HEATING / AIR CONDITIONING  FRONT EVAPORATOR TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 88625 1.INSPECT EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR)

a.

Measure the resistance according to the value(s) in the table below.

E265304
1.208,1.594 1.667,1.823 0.458,0.229 5.135,1.521 5.344,1.167 5.344,1.167 5.51,1.167 false 0.604,0.813 0.813,0.51 0.813,0.51 0.979,0.51 false 0.344,0.135 0.75,0.375 0.406,0.24 10 false *a 1.01,0.417 1.375,0.625 0.365,0.208 10 false *b 4.271,0.146 4.708,0.365 0.438,0.219 10 false *c 5.542,1.063 5.958,1.24 0.417,0.177 10 false *d 5.344,2.583 5.719,2.792 0.375,0.208 10 false *e 4.104,2.115 4.427,2.344 0.323,0.229 10 false 0.0 4.104,1.958 4.427,2.188 0.323,0.229 10 false 1.0 4.104,1.813 4.427,2.042 0.323,0.229 10 false 2.0 4.104,1.646 4.427,1.875 0.323,0.229 10 false 3.0 4.104,1.479 4.427,1.708 0.323,0.229 10 false 4.0 4.104,1.323 4.427,1.552 0.323,0.229 10 false 5.0 4.104,1.167 4.427,1.396 0.323,0.229 10 false 6.0 4.104,1 4.427,1.229 0.323,0.229 10 false 7.0 4.104,0.844 4.427,1.073 0.323,0.229 10 false 8.0 4.104,0.698 4.427,0.927 0.323,0.229 10 false 9.0 4.031,0.542 4.354,0.771 0.323,0.229 10 false 10.0 5.323,2.24 5.646,2.469 0.323,0.229 10 false 10 5.292,2.385 5.698,2.792 0.406,0.406 10 false (50) 5.875,2.24 6.198,2.469 0.323,0.229 10 false 20 6.385,2.229 6.708,2.458 0.323,0.229 10 false 30 5.844,2.385 6.25,2.792 0.406,0.406 10 false (68) 6.354,2.385 6.76,2.792 0.406,0.406 10 false (86) 4.781,2.385 5.188,2.792 0.406,0.406 10 false (32) 4.271,2.385 4.677,2.792 0.406,0.406 10 false (14) 4.854,2.24 5.177,2.469 0.323,0.229 10 false 0 4.292,2.24 4.615,2.469 0.323,0.229 10 false -10 1.354,1.604 1.719,1.813 0.365,0.208 10 false a1
*a Component without harness connected
(Evaporator Temperature Sensor (No. 1 Cooler Thermistor))
*b Sensing Portion
*c Resistance (kΩ) *d Allowable Range
*e Temperature (°C (°F)) - -


Standard Resistance:
Tester Connection Condition Specified Condition
a1-1 - a1-2 -10°C (14°F) 7.30 to 9.10 kΩ
a1-1 - a1-2 -5°C (23°F) 5.65 to 6.95 kΩ
a1-1 - a1-2 0°C (32°F) 4.40 to 5.35 kΩ
a1-1 - a1-2 5°C (41°F) 3.40 to 4.15 kΩ
a1-1 - a1-2 10°C (50°F) 2.70 to 3.25 kΩ
a1-1 - a1-2 15°C (59°F) 2.14 to 2.58 kΩ
a1-1 - a1-2 20°C (68°F) 1.71 to 2.05 kΩ
a1-1 - a1-2 25°C (77°F) 1.38 to 1.64 kΩ
a1-1 - a1-2 30°C (86°F) 1.11 to 1.32 kΩ


If the resistance is not as specified, replace the evaporator temperature sensor (No. 1 cooler thermistor).

NOTICE:
·

Even slightly touching the sensor may change the resistance value. Be sure to hold the connector of the sensor.

·

When measuring, the sensor temperature must be the same as the ambient temperature.



HINT:

As the temperature increases, the resistance decreases (see the graph).