Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR
RM2030EQ _58 Vehicle Interior _014672 HEATING / AIR CONDITIONING _0074666 COMPRESSOR A

HEATING / AIR CONDITIONING  COMPRESSOR  REASSEMBLY  


PROCEDURE

Hide 88410 1.INSTALL MAGNET CLUTCH ASSEMBLY

a.
E231355

Install the magnet clutch stator with the parts aligned as shown in the illustration.


b.
I032461

Using a snap ring expander, install a new snap ring with the chamfered side facing outward.


c.

Engage the clamp.


d.
I031582

Using a snap ring expander, install the magnet clutch rotor and a new snap ring with the chamfered side facing outward.

NOTICE:

Do not damage the seal cover of the bearing when installing the snap ring.



e.

Install the magnet clutch washer(s) and magnet clutch hub.

NOTICE:

Do not change the combination of the magnet clutch washer(s) used before disassembly.



f.
E156530
0.458,1.448 0.615,1.448 0.615,1.448 0.688,1.188 false 0.156,1.354 0.719,1.667 0.563,0.313 10 false SST

Using SST, hold the magnet clutch hub and install the bolt.

SST
07112-76060  

Torque:
18 N*m (183 kgf*cm, 13 ft.*lbf)

NOTICE:

Make sure that there is no foreign matter or oil on the compressor shaft, bolt, and clutch hub.



Hide 88688N 2.INSTALL COOLER BRACKET

a.
E231354

Install the cooler bracket with the screw.


b.

Engage the clamp.


c.

Connect the connector.


Hide 3.INSPECT MAGNET CLUTCH CLEARANCE

a.
E156531

Clamp the cooler compressor in a vise between aluminum plates.


b.

Set the dial indicator to the magnet clutch hub.


c.

Connect a battery positive lead to terminal 3 of the magnet clutch connector and a negative lead to the ground wire. Turn the magnet clutch on and off and measure the clearance.

Standard clearance:

0.35 to 0.60 mm (0.014 to 0.024 in.)


If the measured value is not within the standard clearance, remove the magnet clutch hub and adjust the clearance using magnet clutch washers to obtain the standard clearance.

Magnet clutch washer thickness:

0.1 mm (0.004 in.)

0.3 mm (0.012 in.)

0.5 mm (0.020 in.)


NOTICE:

Adjustment should be performed with 3 or fewer magnet clutch washers.



d.

Remove the cooler compressor from the vise.