The jam protection function operates within a specified range during the manual up or auto up operation.
If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
Initialize the power window regulator motor assembly (for driver door).
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION
| Proceed to |
|---|
| NEXT |
NEXT
Check if the power window auto up and down function operate normally.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK
Driver door auto up and down function is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check if the jam protection function operates normally for the driver door power window.
The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.
Jam protection function operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG