Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM2030EQ _59 Vehicle Exterior _014675 WINDOW / GLASS _0074675 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch  


DESCRIPTION

When the ignition switch is ON, the power window regulator motor assembly (for front passenger door) is operated by the power window regulator switch assembly (for front passenger door).

WIRING DIAGRAM

B246037
4.344,3.094 5.917,3.51 1.573,0.417 10 false Power Window Regulator Master Switch Assembly 6.146,3.104 6.896,3.281 0.75,0.177 10 false *1: for LHD 6.146,3.375 6.896,3.552 0.75,0.177 10 false *2: for RHD 2.354,2.917 3.906,3.458 1.552,0.542 10 false Power Window Regulator Switch Assembly (for Front Passenger Door) 0.323,2.896 1.958,3.385 1.635,0.49 10 false Power Window Regulator Motor Assembly (for Front Passenger Door) 4.344,2.927 5.417,3.292 1.073,0.365 10 false K10*1, J10*2 2.354,2.76 3.344,3.01 0.99,0.25 10 false J11*1, K11*2 0.323,2.74 1.458,3.156 1.135,0.417 10 false J15*1, K14*2 6.167,2.26 6.281,2.406 0.115,0.146 10 false E 6.385,2.25 7.156,2.646 0.771,0.396 10 false 1*1, 9*2 5.208,1.635 5.323,1.781 0.115,0.146 10 false B 5.406,1.417 5.521,1.563 0.115,0.146 10 false 6 4.406,2.042 4.542,2.188 0.135,0.146 10 false U 2.729,1.948 2.865,2.094 0.135,0.146 10 false U 2.563,1.948 2.698,2.094 0.135,0.146 10 false 4 1.365,1.948 1.5,2.094 0.135,0.146 10 false U 1.521,1.948 1.656,2.094 0.135,0.146 10 false 2 3.229,2.042 3.604,2.292 0.375,0.25 10 false SU 3.188,1.906 3.313,2.052 0.125,0.146 10 false B 3.229,2.438 3.573,2.635 0.344,0.198 10 false SD 4.396,2.427 4.531,2.573 0.135,0.146 10 false D 2.729,2.323 2.865,2.469 0.135,0.146 10 false D 2.563,2.323 2.698,2.469 0.135,0.146 10 false 1 1.365,2.323 1.5,2.469 0.135,0.146 10 false D 1.521,2.323 1.656,2.469 0.135,0.146 10 false 1 3.198,1.719 3.333,1.865 0.135,0.146 10 false 3 3.51,2.042 3.646,2.188 0.135,0.146 10 false 5 3.677,2.042 4.563,2.323 0.885,0.281 10 false 16*1, 12*2 3.677,2.438 4.594,2.75 0.917,0.313 10 false 15*1, 13*2 3.51,2.438 3.646,2.583 0.135,0.146 10 false 2 2,0.896 3.063,1.198 1.063,0.302 10 false DOOR NO. 1 0.271,0.729 1.604,1.01 1.333,0.281 10 false from DOOR Relay

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR FRONT PASSENGER DOOR) - BATTERY)
a.

Disconnect the power window regulator switch assembly (for front passenger door) connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
for LHD
Tester Connection Condition Specified Condition
J11-3 (B) - Body ground Ignition switch ON 11 to 14 V

for RHD
Tester Connection Condition Specified Condition
K11-3 (B) - Body ground Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR FRONT PASSENGER DOOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR FRONT PASSENGER DOOR)
a.
B164433
2.167,2.188 2.375,2.74 false 1.927,2.188 2.052,2.74 false 1.542,2.188 1.448,2.74 false 1.302,2.188 1.104,2.74 false 1.75,2.188 1.75,2.74 false 0.198,0.219 0.385,0.365 0.188,0.146 10 *a 1.385,2.74 1.521,2.885 0.135,0.146 10 U 0.979,2.74 1.229,2.938 0.25,0.198 10 SU 2.375,2.74 2.51,2.885 0.135,0.146 10 D 1.698,2.74 1.833,2.885 0.135,0.146 10 B 1.979,2.75 2.198,2.896 0.219,0.146 10 SD
*a Component without harness connected
(Power Window Regulator Switch Assembly (for Front Passenger Door))


Remove the power window regulator switch assembly (for front passenger door).

Click hereVehicle Exterior>WINDOW / GLASS>FRONT PASSENGER SIDE POWER WINDOW SWITCH>REMOVAL


b.

Measure the resistance when the switch is operated according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (D) - 2 (SD) UP Below 1 Ω
3 (B) - 4 (U) Below 1 Ω
1 (D) - 2 (SD) off Below 1 Ω
4 (U) - 5 (SU) Below 1 Ω
4 (U) - 5 (SU) DOWN Below 1 Ω
1 (D) - 3 (B) Below 1 Ω



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH (FOR FRONT PASSENGER DOOR) - POWER WINDOW REGULATOR MOTOR)

NG

REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR FRONT PASSENGER DOOR)

3.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH (FOR FRONT PASSENGER DOOR) - POWER WINDOW REGULATOR MOTOR)
a.

Disconnect the power window regulator motor assembly (for front passenger door) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
for LHD
Tester Connection Condition Specified Condition
J11-4 (U) - J15-2 (U) Always Below 1 Ω
J11-1 (D) - J15-1 (D) Always Below 1 Ω
J11-4 (U) - Body ground Always 10 kΩ or higher
J11-1 (D) - Body ground Always 10 kΩ or higher

for RHD
Tester Connection Condition Specified Condition
K11-4 (U) - K14-2 (U) Always Below 1 Ω
K11-1 (D) - K14-1 (D) Always Below 1 Ω
K11-4 (U) - Body ground Always 10 kΩ or higher
K11-1 (D) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
a.
B164359
2.365,1.792 2.635,2.708 false 1.563,1.781 1.75,2.719 false 1.552,2.021 1.438,2.698 false 1.396,2.021 1.167,2.708 false 2.031,1.99 2.292,2.688 false 1.896,1.99 1.979,2.688 false 1.063,1.802 0.677,2.688 false 0.198,0.083 0.385,0.271 0.188,0.188 10 *a 1.01,2.729 1.302,2.958 0.292,0.229 10 U*A 1.333,2.729 1.646,2.938 0.313,0.208 10 D*A 1.719,2.729 1.854,2.917 0.135,0.188 10 B 2.583,2.74 2.927,2.979 0.344,0.24 10 E*A 2.229,2.74 2.521,2.969 0.292,0.229 10 U*B 1.906,2.729 2.219,2.938 0.313,0.208 10 D*B 0.531,2.74 0.875,2.979 0.344,0.24 10 E*B
*A for LHD
*B for RHD
*a Component without harness connected
(Power Window Regulator Master Switch Assembly)


Remove the power window regulator master switch assembly.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW MASTER SWITCH>REMOVAL


b.

Measure the resistance when the switch is operated according to the value(s) in the table below.

Standard Resistance:
for LHD
Tester Connection Condition Specified Condition
6 (B) - 16 (U) UP Below 1 Ω
1 (E) - 15 (D) Below 1 Ω
1 (E) - 16 (U) off Below 1 Ω
1 (E) - 15 (D) Below 1 Ω
6 (B) - 15 (D) DOWN Below 1 Ω
1 (E) - 16 (U) Below 1 Ω

for RHD
Tester Connection Condition Specified Condition
6 (B) - 12 (U) UP Below 1 Ω
9 (E) - 13 (D) Below 1 Ω
9 (E) - 12 (U) off Below 1 Ω
9 (E) - 13 (D) Below 1 Ω
6 (B) - 13 (D) DOWN Below 1 Ω
9 (E) - 12 (U) Below 1 Ω



Result:
Proceed to
OK
NG



OK

5.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH - POWER WINDOW REGULATOR SWITCH (FOR FRONT PASSENGER DOOR))

NG

REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY

5.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH - POWER WINDOW REGULATOR SWITCH (FOR FRONT PASSENGER DOOR))
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
for LHD
Tester Connection Condition Specified Condition
K10-16 (U) - J11-5 (SU) Always Below 1 Ω
K10-15 (D) - J11-2 (SD) Always Below 1 Ω
K10-16 (U) - Body ground Always 10 kΩ or higher
K10-15 (D) - Body ground Always 10 kΩ or higher

for RHD
Tester Connection Condition Specified Condition
J10-12 (U) - K11-5 (SU) Always Below 1 Ω
J10-13 (D) - K11-2 (SD) Always Below 1 Ω
J10-12 (U) - Body ground Always 10 kΩ or higher
J10-13 (D) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR FRONT PASSENGER DOOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR