Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM
RM2030EQ _59 Vehicle Exterior _014679 WIPER / WASHER _0074707 WIPER AND WASHER SYSTEM L

WIPER / WASHER  WIPER AND WASHER SYSTEM  PRECAUTION  


PRECAUTION FOR DISCONNECTING THE BATTERY CABLE


NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected:


System See Procedure
Parking Assist Monitor System (Click here)


IGNITION SWITCH EXPRESSIONS


The type of ignition switch used on this model differs according to the specification of the vehicle.

The expressions listed in the table below are used in this section.

Expression Ignition Switch (Position) Engine Switch (Condition)
Ignition Switch off LOCK Off
Ignition Switch ACC ACC On (ACC)
Ignition Switch ON ON On (IG)
Engine Start START Start


PRECAUTION OF WASHER NOZZLE ADJUSTMENT


a.

Do not clean or adjust the washer nozzle with a safety pin, etc. because:

i.

The washer nozzle tip is made of resin and could be damaged.


ii.

Adjustment is not necessary for this spray type washer nozzle. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle.



b.

If the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush or other cleaning tool.