Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE › 2012.02–2015.04
RM2030EQ _59 Vehicle Exterior _014679 WIPER / WASHER _0074712 WASHER NOZZLE G

WIPER / WASHER  WASHER NOZZLE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85035 1.INSPECT WASHER NOZZLE SUB-ASSEMBLY

a.

With the ignition switch to ON, check the position that the washer fluid hits the windshield.

Standard:

Washer fluid hits the windshield in the areas shown in the illustration.


E226091
5.052,2.479 5.271,2.479 false 4.792,3.323 5.021,3.323 false 5.427,4.25 5.01,4.25 false 1.875,2.479 2.083,2.479 false 2.125,3.323 2.354,3.323 false 2.135,4.25 1.719,4.25 false 4.083,1.188 4.354,1.448 0.271,0.26 10 A 2.979,1.188 3.229,1.438 0.25,0.25 10 A 4.656,4.604 5,4.906 0.344,0.302 10 B 3.875,5.573 4.135,5.823 0.26,0.25 10 C 3.198,5.573 3.51,5.854 0.313,0.281 10 C 2.094,2.385 2.406,2.656 0.313,0.271 10 *a 2.365,3.24 2.719,3.521 0.354,0.281 10 *b 1.563,4.146 1.917,4.417 0.354,0.271 10 *c 4.906,2.385 5.188,2.656 0.281,0.271 10 *a 4.646,3.24 4.896,3.521 0.25,0.281 10 *b 5.458,4.146 5.833,4.458 0.375,0.313 10 *c
*a Upper Limit *b Standard
*c Lower Limit - -


Standard Clearance
Area Measurement Area Measurement
A 300.0 mm (11.8 in.) B 145.0 mm (5.71 in.)
C 170.0 mm (6.69 in.) - -

HINT:

If the result is not as specified, replace the washer nozzle sub-assembly.