Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER SWITCH › 2012.02–2015.04
RM2030EQ _59 Vehicle Exterior _014679 WIPER / WASHER _0074715 HEADLIGHT CLEANER SWITCH G

WIPER / WASHER  HEADLIGHT CLEANER SWITCH  INSPECTION  


PROCEDURE

Hide 84150D 1.INSPECT HEADLIGHT CLEANER SWITCH ASSEMBLY

a.
E136319C12
1.49,0.5 1.99,0.781 0.5,0.281 1.615,1.344 1.219,0.844 false 1.833,1.344 2.24,0.885 false 2.031,1.417 2.531,1.417 false 1.406,1.417 0.958,1.417 false 0.177,0.135 0.479,0.385 0.302,0.25 10 *a 0.802,1.313 1.01,1.542 0.208,0.229 10 B 0.906,0.677 1.333,0.917 0.427,0.24 10 ILL+ 2.198,0.688 2.583,0.906 0.385,0.219 10 ILL- 2.594,1.323 2.854,1.542 0.26,0.219 10 L 1.677,0.552 2.073,0.813 0.396,0.26 10 I9
*a Component without harness connected
(Headlight Cleaner Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
I9-1 (L) - I9-4 (B) Headlight cleaner switch on Below 1 Ω
Headlight cleaner switch off 10 kΩ or higher



b.

Connect a battery positive (+) lead to terminal I9-3 (ILL+) and a negative (-) lead to terminal I9-2 (ILL-).


c.

Check that the headlight cleaner switch assembly illumination comes on.

OK:

The headlight cleaner switch assembly illumination comes on.


If the result is not as specified, replace the headlight cleaner switch assembly.