Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER SWITCH › 2012.02–2015.04
RM2030EQ _59 Vehicle Exterior _014679 WIPER / WASHER _0074715 HEADLIGHT CLEANER SWITCH A

WIPER / WASHER  HEADLIGHT CLEANER SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION (for RHD)

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for RHD)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 62312B 3.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

Hide 55318C 4.REMOVE INSTRUMENT SIDE PANEL

Hide 55431B 5.REMOVE UPPER INSTRUMENT PANEL FINISH PANEL (for RHD)

Hide 55650 6.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55410C 7.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 84150D 8.REMOVE HEADLIGHT CLEANER SWITCH ASSEMBLY

a.

for LHD:

i.
E246072

Disengage the 2 claws and remove the headlight cleaner switch assembly.



b.

for RHD:

i.
E246073

Disengage the 2 claws and remove the headlight cleaner switch assembly.